Recent content by Rugid

  1. R

    Charging Issues

    Ok so my charging system isn't charging my battery. How do I go about testing the charging components? Year and size of motor is still yet to be determined. Here's all the info I have so far. model # 62B8J. Purchased on Aug. 7/78 And there are some pics in this thread...
  2. R

    What year, size Frank?

    Well I have been trying to figure out what my Chrysler actually is for over a year now. See thread http://forums.iboats.com/showthread.php?t=425252 Well i finally got my hands on the original registration card. So the model # 62B8J. Purchased on Aug. 7/78. So what size, year is she? Your help is...
  3. R

    Early 70's 135 hp Starter

    When I go to start the starter pinion gear sometimes doesn't mesh with the flywheel correctly. I turn the key and the starter will spring up and hit the underside of the flywheel then spring back down. This can go on for sometime if I don't manually line up the teeth. Is there an adjustment I...
  4. R

    Early 70's 70-85 hp Lower Unit * Fixed *

    Last year on my last outing on the lake my lower unit would slip out of gear once I started to bring on the rpm's or when she was under load ( towing a tube etc ). So this winter I disassembled the lower unit and ground the clutch dogs even and inspected the forward and reverse gear. The forward...
  5. R

    Service Manual

    I'm looking for digital service manual for a pre 75 Chrysler 105. Regarding the lower unit. Your help is appreciated.
  6. R

    Ignition

    I have a early 70's 140? Chrysler outboard. The engine has Motorola ignition with the finned regulator. The distributor is single wire points. On a belt drive. She will not fire unless someone hits ( with force ) the power pack while cranking. She pops a few times, then after 5 mins of cranking...
  7. R

    What year?

    I have some issues with my 105. So first thing I need to get to the bottom of is what year she is? Model # is 10576 I'm guessing late 70's
  8. R

    Slipping out of gear

    I'm new to outboards so your help would be appreciated. I have a Chrysler 105 ( late 70's I believe. Not sure on the year ). She will move into gear forward and reverse fine. Low rpm's she behaves normally. But as I bring on the rpm she slips into neutral. Do these units have a clutch? How do I...
See more
Top