Total cost to remove the outboard was 2 milkshakes. I can't believe my kids charged me to use their play set. My make shift stand worked amazing to get it into the shed. Overall It went better then planned probably not the best setup but it worked!!!!
Just replaced the choke switch on the boat and after a few uses its burnt out again. What amp switch should I be using? not sure on the amps on the old one I just matched the new one up with the existing one. All the switches I've ever seen have been push button and this is a toggle not sure if...
So I replaced the switch on the choke. I started it up and after a few min I noticed smoke coming out of the choke, shut it off and noticed it was still smoking for several mins. I?m guessing it?s burnt up since it won?t engage. I shopped around and all I could find was used parts. My question...
I was in the process of replacing the drive shaft bearing when I saw this hole. I'm pretty sure its not suppose to be there, would I be fine just filling with JB Weld? The hole isn't all the way through just a cavity.
So I just bought a 74 Cruisers 18' with a 120hp Chrysler, I noticed the orange wire in the pic hanging under the controls it?s hooked to the ACC on the switch well my ? is what would that go to. I was thinking the radio or the fish finder. Is there a designated area for it? Also the throttle arm...
