ryno1234's latest activity

  • ryno1234
    ryno1234 reacted to tango13's post in the thread Leak through transom with Like Like.
    Been watching this thread - is it possible that your housing is corroding bad in that spot and has a pin hole leak? Curious of the...
  • ryno1234
    ryno1234 reacted to tank1949's post in the thread Leak through transom with Like Like.
    I have replaced two transoms on I/Os. Its a job!!!!!!! Or 5-7 grand out of pocket. Use the boat the rest of summer and get working on it...
  • ryno1234
    ryno1234 replied to the thread Leak through transom.
    The only place I've found drips are in the red circled area in this image. You make a good point that water can be pushed UP. I didn't...
    • Gimbal housing leak.jpg
  • ryno1234
    ryno1234 reacted to ShoalSurvivor's post in the thread Leak through transom with Like Like.
    If the green line is sealed all the way around, then the water would not be coming in from the seal. It would have to be entering...
  • ryno1234
    ryno1234 replied to the thread Leak through transom.
    I'm going to try to rule out the penatrations as you suggested. Y-Pipe is good - I've put a bore scope there and didn't notice any...
  • ryno1234
    ryno1234 reacted to ShoalSurvivor's post in the thread Leak through transom with Like Like.
    I cannot tell what the video is looking at, but, water flows down ;), and could just be accumulating in the well. I wanted to find...
  • ryno1234
    ryno1234 replied to the thread Leak through transom.
    Thank you so much for your detailed post this helped, especially the diagram. It inspired my to make my own to clarify my leak location...
    • Gimbal housing leak.jpg
  • ryno1234
    ryno1234 reacted to cwella's post in the thread Leak through transom with Like Like.
    Check the shift cable bellows, U-joint bellows, trim sender wires, and gimbal housing seal. A bellows can look fine but still have a...
  • ryno1234
    ryno1234 replied to the thread Leak through transom.
    I checked the shift cable bellows, no leak coming from that. (I updated my last post to make that clear) Also, it's clear that the leak...
  • ryno1234
    ryno1234 replied to the thread Leak through transom.
    Update: I was able to find the source of the leak. Here's what I did prior to my testing: Drain plug issue fixed - new plug, same...
  • ryno1234
    ryno1234 replied to the thread Do it yourself Pumpout?.
    I have an extra macerator that screws on to my waste outlet outside of the boat. I have had to thread the macerator on to the outlet and...
  • ryno1234
    ryno1234 reacted to nola mike's post in the thread Leak through transom with Like Like.
    That looks like a PVC insert? Don't like the looks of that screw hole. Id still drill it inside around the hole.
  • ryno1234
    ryno1234 replied to the thread Leak through transom.
    I pulled the plug housing and it doesn’t seem rotted in that area - although I cannot be 100% positive. Everything I can see looks like...
    • image.jpg
  • ryno1234
    ryno1234 replied to the thread Leak through transom.
    Update: I put the scope back around the hydraulic lines going through the gimbal housing and the water that has collected previously is...
  • ryno1234
    ryno1234 reacted to nola mike's post in the thread Leak through transom with Like Like.
    Tap test is garbage. IMO drilling is the only way to check. Even fancy moisture meters in capable hands are subject to interpretation...
Show older items
Top