Anyone know where i can get a new honda 130 counter rotating lower unit for a 2003 motor from? They are back ordered through honda. I need it complete from driveshaft to skeg.
I have a 1997 mariner 40 hp motor that doesnt run right. It is manual start 3 cylinder with CD ignition. The motor has only around 25 hours on it. As i am going along with it on the boat it runs full throttle for around 10 minutes then cuts back to around 1/4 throttle. I took it out of the water...
I am currently working on reglassing the deck on a 1973 13 ft whaler. It has all ben ground down with a grinder to get all the paint off. All there is now is fiberglass below. The reason for reglassing the deck is because of some minor crack all over the floor. Floor does not felx to bad only...
I am currently interested in purchasing a 1995 sea doo sportster. I believe it is a 85 hp motor. The motor is junk. I have a 717cc motor out of a 1995 sea doo xp. Was wondering what motor the sportster had in it and if the electronics are the same??? Any help would be appreciated.
Checked compression on a 1960's johnson v4 75 hp outboard. Compression read 60lbs in all cylinders. Motor has been sitting for who knows how long. Is that compression acceptable? Thanks
Two days ago in West Warwick Rhode Island at 11:00 P.M. A fire broke out at a night club called the station. A band was playing there last night. They used pirotechnics on the side of the stage. As they were singing there first song the pirotechnics were going off. The sound dednening on the...
Snow is going to start flying tomorrow morning or late tonight... Forcasting 15-24 inches of snow.... Now how am i expected to work on any boats in this??? I cant wait for spring. Anyone on hte board get hit with this snow storm yet?
I have been looking for a used driveshaft for a 1980's 6-8 hp johnson evinrude outboard motor 15" if anyone knows where i can get one please let me know thanks
Started working on a 1974 mercury 65 hp 3 cylinder motor. No spark... replaced the switch box with a CDI switch box... Still no spark... Stator looks fine... winding are not covered with plastic. Jumping the motor over with pos on starter and neg on starter right to the battery. Do i need to...
Brand new Aluminum Trailers from 12-65 feet. Single, dual, triple axel. All aluminum with disc brakes. Please E mail or post for mor info will delever to east cost
I have a late 80's 8 hp mercury outboard. The motor only has around 30 hours on it total. It starts and runs fine. Goes into gear smooth. But when I am about half throttle it kicks out of gear back into neutral. Reves up high and I have to turn the motor off. Clutch dog???/ Any ideas would...
