Recent content by Safebet

  1. S

    Cylinder cap removal on tilt and trim 50 hp 1998 evinrude

    I need to replace the o-rings in my tilt and trim cylinder. Is there a special tool available to remove the top cap? It looks like it has for indents in a box pattern in the top of the cap. What can I do to remove the cap? Thanks Jim Diana, Texas
  2. S

    TRANSOM ANGLE GRUMMAN 1855b

    Does anyone know what the transom angle is for a Grumman 1855 B? Also, It appears it once had a small windshield on the console. Do you know where I get get a replacement? At present, I am restoring one. Great built boats, lots of aluminum structure and foam. Won't sink.
  3. S

    55# Evinrude Trolling Motor

    I have a 55#, 12/24 volt trolling motor, hand control, with a 2 blade plastic prop that I need to replace. It is 3-speed forward, pull the hand out and it's 3 speed backwards. My boat is a 1985 18' Ebbtide DynaTrak 179. The tolling motor works great. I can find no numbers on the trolling...
  4. S

    Help: Hooking up tachometer

    I have a 1985 Yamaha, Model 150 ETLK, mounted on a Ebbtide 179 Dyna Trak. I am attempting to install missing tachometer. I have the following wires: 2 green wires tied together, which I think goes to the "signal" post. 1 black wire which, I'm sure is ground, goes to "Grnd" post. 1 purple...
  5. S

    1986 Yamaha 150 HP Yamaha

    I have just purchased a boat with a 150 HP Yamaha (1986) engine that has not been run for 5 years. It was running fine when stored. What are some of the first steps I should take to get this motor running, again. Thank you Jim
  6. S

    Need A Rapair Manual

    I have a 4 hp Evinrude that was given to me. The model # is E4BRHCOB and the serial # is B102118. The nameplate says the engine was manufactured in Belgium. I would like to have a repair and parts manual for it. Can anyone tell me what year model it is? If I know the year than I can order the...
See more
Top