I have a crated 2014 Mercury 115 and need to lift it out of the crate and onto my boat, I know that Mercury has a lifting tool for this application which is a flywheel puller and lifting ring all in one from $180.00 to $300.00. Question I have is there a product out there which does the same job...
Again I need your asistance ...... I have a Trophy Bayliner 1802 with a 2002 Merc 125 Classic outboard. Everything is running great except for the gauges. I must have a ground problem somewere ..... The Tac. works on and off as well as the Fuel Gauge, all of the gauges light up but do not work...
Ran into a problem today ...... I'm in the process of changing over my 2002 Merc 125 Saltwater Classic outboard side mount control. I managed to get my hands on a 4000 Gen II Shifter Assembly, this style of controller will only use Gen II trottle and shifter cables which makes my old merc...
I'm in the process of changing over my side mount shifter assembly to the new style 4000 Gen II. Question?? Will the Gen II throttle and shifter cables work on my 2002 Mercury 125hp SaltWater series Outboard.
Thanks
SailFin
I have a 2002 Mercury 125HP SaltWater Series outboard one of those 2+2 models. The problem I'm having is that it is very hard to start .... when it is cold and even when it is warmed up and shut down for 20 minutes it turns over forever before it starts. I bought this motor from a gentleman in...
I have a 2002 Mercury 125HP SaltWater 4 cylinder 2 stoke outboard ... Does anyone out there know what this engine should idle at when it's idiling in neutral with the muffs on ?? The mannul states that when the engine under load or in the water should idle at 650-700 rpm's in foward gear ...
Thanks
I have a 1995 Force 120 on a 1802 Trophy, The motor runs great but will not trim out. The motor can be raised and lowered with ease , when the motor is left in the highest postion for sometime there is no weeping. Question ... when the motor is raised from the lowest postion should it start out...
I have a 1995 Force 120 ... The problem I have is that the motor will not trim when the boat is tring to get on step, if I play with the trim switch long enough the motor will trim. The tilt trim works fine when the boat is not in motion. Could this not be a electrical problem ?? I have replaced...
