My neighbor is looking at a boat and I went along with him. The motor is a 40 Hp Mercury 4Cyl 2 stroke and we cannot find the motor tag anywhere on the motor. Most motors I have seen have it on the mounting bracket or on the front of the handle area and this one it does not seem to be there. If...
Can anyone tell me how to remove the handle on this omc control?
This is a picture I found of it.
I am redoing the side panels of my boat and I cannot for the life of me figure out how to seperate the handle from the control so that I can take it off.
I recently acquired a 60 johnson that starts ok but doesn't idle very well after running for 10 min or so. I think it may to have the carbs cleaned as the fellow I bought it from said he didn't use it for the last 2 years.anyway I ran it in the lake and it started running fine and then I backed...
I have a 89 dt55 that sets off the waterflow alarm but the telltale is strong. I replaced the impeller and plate and same thing. The top cylinder seemed very warm, I couldn't hold my hand on it but the bottom 2 seemed cooler. The telltale temp seemed warm enough to wash your hands with.Is this...
I started this motor up and there was no water coming out for the first few minutes. I shut it down and then started up again, the stream was on now and seemed strong. Is there a thermostat on these motors?
A friend bought a theft recovery from auction.<br />We think its a 20hp but no way to tell.<br />To obtain parts he'll need some info. Does anyone know if there is info on the block? The serial tag is chiselled off and the other side is grinded.<br />If anyone has any clues as to year please...
