Hey again guys. Gotta love when you get all the things you need than get busy as hell at work without the time to do it always fun. I have my new plywood cut to shape for the transom and planned on using PL premium to bed it into place. My question is if I do go with PL for bedding material...
getting ready to put new transom into boat this weekend than moving onto stringers. My last real question is do i encase the stringers completly in glass than tab them onto the hull or do I bed them than glass right around them leaving the bottom side with just the pl? Have been able to get...
Hey again guys just one quick question. I've searched high and low in town and surrounding areas for 24 or 36 grit sand paper. Lowes, Home Depot, Even hit Harbor freight and Northern tool. All seem to be out when i arrive and still out. So I went another route and used my grinder with a...
I've been doing alot of reading and am down to deciding what type of cloth to use for the transom and stringer job. I am going with the 435 poly resin from us composties. My question is can i use a 1.5 oz csm product for between transom layers and on stringer than finish it out with mat? I...
Well after pouring through here and reading tons of posts(awesome advive and info for other noobs to site btw) I finally pullis the 65 hp evinrude off back and started the demo. I have a few questions after seein a few things after starting. I noticed when I started gettin rdy to pull cap the...
I remember reading a post with a link to a salvage dealer in georgia with a rather large selection of boats in need of restoration just dont remember the thread it was on. If anyone can give me some info on where i might find just a place that would be highly appreciated
Hey guys new to forum here, been reading for quiet a while and goin to jump into deck,transom, and stringer project. Free boat with 1973 65hp Evinrude on back motor runs glass hull in good shape but stringer and deck rotten right out. I plan on using plywood for stringers and sealin them in...
