Wow, have I got a winner here! My son came home with an EVINRUDE "SUPER 25 FIRE POWER IGNITION" 25HP outboard (whatever that is). The model number is SE25RSM. The nearest I can tell is that this may be the South American, maybe commercial model 25. I have found a "25RSM/25RSLM" in the official...
Hey Guys:
My son just bought a 1988 40 HP Oil injected Yamaha outboard. We noticed what appears to be oil leaking out from the water intakes. I do not think it is lower unit fluid. There is some oil around the bottom of the engine compartment as well...I was thinking this may be due to the...
Re: 1991 Force 120HP Tilt/Trim Overhaul Kit?
Thanks for the reply. The motor still functions fine....I just have the Engibe lowering slowly after I tilt it up. I attached a picture of the tilt/trim unit. First time doing this, so I'm not sure I've done it right.
Thanks again,
Scott.
Hey Guys/Gals:
Does anybody know if their is actually a rebuild kit for these tilt/trim motors? I have a bleed down problem. In the full up position, the motor will be almost all the way back down within about 15 minutes. I have a repair manual that describes how to isolate the condition & I...
My son and I came across a 6HP with both a low speed and high speed carb adjustment. Needle valves and packing need replacing. Does anybody know where I might find an exploded parts diagram for the carb w/part numbers? Also, if you know of a good source for older parts like this, please advise...
