Scott06's latest activity

  • Scott06
    Scott06 replied to the thread Oil Pressure Sender failure modes?.
    Well yes and no... I think the factory OP switch is tripped at 4 or 7 psi .... so at lower rpms yes it may save an engine but higher...
  • Scott06
    Scott06 replied to the thread Oil Pressure Sender failure modes?.
    yeah always watching OP and temp. Had an over heat last summer due to weeds on outdrive... had been towing my daughter skiing then...
  • Scott06
    Scott06 replied to the thread Oil Pressure Sender failure modes?.
    you must be bored or out of beer... looks like the thing works now so leave it alone. Seriously though I converted my factory gauge...
  • Scott06
    Scott06 replied to the thread No Trailer and Trim Up.
    your description makes sense, but the switch being NO is opposite of way you would think it would work... would think its NC until...
  • Scott06
    Scott06 replied to the thread Bravo 1 to Bravo 3 Conversion.
    if 6 ppl plane out time was good you are probably in the ballpark. Will be lucky $$$ if you can run the same props.
  • Scott06
    Scott06 replied to the thread Main Jet size for carb 7043183?.
    As Ad points out I have seen it for some carbs in the carb section of manual or some addendums, but not for anything that old. I think I...
  • Scott06
    Scott06 replied to the thread No Trailer and Trim Up.
    Do you have a wiring diagram for your set up? I know the earlier ones are a bit more complicated... If i recall you have the three...
  • Scott06
    Scott06 replied to the thread Main Jet size for carb 7043183?.
    Sometimes you see them in the carb tune up specs in the factory manual but a quick search I cant find it either... How do the plugs...
  • Scott06
    Scott06 replied to the thread Bravo 1 to Bravo 3 Conversion.
    How did the WOT rpm land - are you good with props you have ?
  • Scott06
    Scott06 replied to the thread Found some rocks with my prop....
    If you got one you are happy with get another. prop MD in MN does mail order repairs if you want a spare
  • Scott06
    Scott06 replied to the thread Alpha1 Gen2 Oil Reservoir Missing?.
    Some early ones did not have a lube bottle.
  • Scott06
    Scott06 replied to the thread salt water in single cylinder.
    It will have a mercrusier serial number tag riveted by the starter Mercuriser buys gm base engines/ long block and builds them out so...
  • Scott06
    Scott06 replied to the thread salt water in single cylinder.
    090M is for metric. For some reason they used metric fasteners on some of the 4.3 blocks... in true GM fashion only some of the threads...
  • Scott06
    Scott06 replied to the thread Cant start engine when opening throttle. Mercruiser 3.0.
    yes you can jumper around the neutral safety switch , but remember its there for a reason. May be an issue with the controller and not...
  • Scott06
    Scott06 replied to the thread aluminum prop comparison.
    Based on that feel I would go up 2" in pitch would probably get you there but you might loose holeshot and pulling ability some. you...
Show older items
Top