I pulled my boat home from storage last night and found one of the locknuts on the trim rams was broken in half. Most of the trim ram pivot bushings look kind of old so I'm wondering if there is a bushing/hardware kit available. This is for a 1994 VP SX-C.
1994 Campion with a Volvo Penta 4.3 GL
Went to hook up the battery for a first start after winter storage. There were no signs of any rodent activity. I hooked up the positive and wrenched the nut on the terminal. Then I hooked up the negative and noticed a fairly large spark. It seemed fine so...
1994 Campion Allante 18' bowrider with a Volvo Penta 4.3GL/SX. When tilting the drive all the way up, it hits the underside of the moulded in swim platform. Actually, the limit switch cuts out the tilt pump before it actually makes contact, but the drive clearly does not tilt high enough for...
I have a 1994 Campion Allante 180 with a Volvo Penta 4.3 GL/SX. This boat porpoises all the time unless I have someone sitting in the bow. This is with the outdrive trimmed down as far as it can. The bow design only has a small anchor locker in the front. I don't think I could fit much in the...
Just bought a 1994 Campion 18' bowrider with 4.3 VP. The trailer has been set up the same for at least 3 years. But to me it looks like it is set up incorrectly. The boat sits about 10-12" forward of the rear end of the bunks.
I know I should just measure total weight and tongue weight, but I...
Hi,
I just bought a '94 Campion Allante 180 Special Edition bowrider with Volvo Penta 4.3GL/SX. The rear of the boat has a slight molded "swim platform" across the boat. When I tilt up the stern drive, it hits the underside of the platform before it is all the way up. The bottom of the leg is...
