Recent content by sea-ray steve

  1. S

    1991 johnson 60hp

    I am looking at a 91 60hp 3cly Johnson.I had a friend tell me to stay away from it because they are noted to have lower unit problems and you can`t find parts.Anyone know anything about that?
  2. S

    starving for fuel

    How much fuel pressure should a 1983 40hp twin cly single carb have between the fuel pump and the carb?
  3. S

    83 40hp merc

    I have a 1983 40hp twin cly single carb that will start and idel great but bogs down under load.If I nurse the throttle up it will run but skips bad,if I throttle up quick it will quit.I have put a kit in the carb and fuel pump,replaced all hoses ,fittings,filter and tank.My compression is 95...
  4. S

    83 40hp merc

    Where are the reed valves located on a 1983 40hp twin cly single carb merc
  5. S

    1983 40hp merc

    Can I convert a 1983 40hp twin cly single carb to fuel injection,if so where would I find the kit?
  6. S

    1983 40hp twin cly Merc, help

    I have a 1983 40hp twin cly merc.It starts and idels great buts starts skipping about a third throttle under load,put a kit in carb,kit in fuel pump,changed coils.Plugs are dry black.compression is 95and92.Am I right thinking its an air-fuel problem with the dry black plugs?Anyone have any...
  7. S

    torque spec

    can anyone tell me the torque spec on the head bolts on a 1983 40hp mercury and the sequence,thank you
  8. S

    1983 merc 40hp skipping at half throttle

    my 1893 40hp merc is skipping at half throttle,changed plugs,no help.Runs good at idle speed,and clears up and runs good wide open.HELP!
  9. S

    Lost Washer

    While removing the lower unit on my 1976 25hp evinrude to replace the impeller I dropped a washer from the shift rod coupling into the housing.After removing the lower unit and not thinking about the washer,I tipped the motor upside down to check the water tube for a restriction,now I can`t find...
  10. S

    Help!

    I have a 1976 25hp evinrude that has been overheating,Now I have a bigger problem.While disconnecting the shift rod to remove the lower unit I dropped a washer from the coupling into the housing.After removing lower unit I tipped the motor upside down to check the water tube for a...
  11. S

    1976 25hp overheating

    replaced the impellar,still not pumping water.there was no impellar in lower unit when I got the motor.should the ears on the impellar be pointing to the left or the right.i installed the new impellar with the ears pointing to the left,but its still not pumping water.
  12. S

    no spark

    i have a 1976 evinrude 25hp rope start,not getting spark.i replaced the ignition coils and sill nothing,points look good. is there any way to check the driver coils and could they cause my problem?
  13. S

    throttle cable

    i have to replace the throttle cable on my 1976 sea-ray srv220 mercruiser 233hp.how do i remove the shifter to get started?
See more
Top