Hi achris,
Thanks for the info and the lesson. Origanally the boat had a MC 1 and I upgraded it to and alpha one back in 2000, the gimbal housing is origanal.
Thanks,
Steve
Hi Bt Doctor,
I am pretty confident I have the lines correct. I am goung to pull the whole system out of the boat and set it up on a table and try to figure it out.
Thanks,
Again,
Steve
H
Hi Bondo,
Thanks for the help. I have read through some older posts and saw that you and Don have just eliminated the Prestolite system and went with the updated newer trim system. I have three reasons that I would like not to have to do that. One I have about $1000.00 into trying to solve...
Hi Kenny, thanks for the response. I will post a picture of the lines coming from the manifold. I marked the lines before removing them and double-checked the manual. the line set up is front of the manifold (fore) to front of the piston and rear of the manifold (aft) to the rear of the piston...
Hi, I am having trouble with my 1978 23' Sportscraft Inline 6 outdrive trim system. The trim system is a Pre Alpha Prestolite system (high-pressure low volume). I have replaced many parts of the system and I am getting nowhere. I have bled the system, replaced the trim pump, valve body, and...
Hi I am looking for information on how to convert my Chevy inline six cylinder Mercruiser to 1/2 closed cooling system. The engine is rebuilt and has not ben run yet (no rust in the block). I saw a post from Bondo to Freebee Tony on April 30th 2009 but can't find the information in iboats.Thanks...
