The spare on the harness says 20amp. However I was curous what amp the system is because in my manual it shows different ohm tolerances for different amp circuits.
i got out there to tinker with it today. I took the powerpacks out inspected them and reinstalled them. Put the 7/16'' gap tester on the first plug wire. hit the trigger ignition and the boat fired right up. I didn't prime it didn't touch anything just hit the ignition. Yes i had the water on...
agreed! i am leaning toward coil pack/coils or bad ground because when i had the gap tester hooked up to the coil and grounded it to the motor and had my buddy turn the key to test the gap the boat fired right up.
Hey guys, motor is a 98 johnson 150, I got the fuel restriction issue all taken care of I had. Rebuilt all 6 carbs and ran new fuel lines and filters. Now I think im having a stator or powerpack issue. When i was out fishing and shut the motor down to fish it took a few tries to get the motor...
Hey guys, so I finally got the motor running good! Had a cel replaced all fuel lines filters and pickup tube/anti siphon valve. Didn’t fix it. Ended up putting 6 rebuilt carbs in and it runs great now. Only thing I noticed was the boat leaning to the left and if I let go of wheel it would turn...
Hey guy, wondering if anybody can steer me in the right direction on how to sync the carbs on my 98 johnson 150. I have a carb sync tool. Just not sure where to hook up to on these motors. Any help is appreciated!
Hey guys, so I have a 98 Johnson 150 ocean runner. It ran great when I bought it. Then had water in fuel issue. Wouldn’t start. I drained the carbs cleaned out tank and changed the plugs and it fired right up. Took it out and had a check engine light and the engine would bog down/ surge then...
