I'm looking for the connecting rod torque value for a 1996 mariner 6o hp 3 cylinder. I have conflicting values one source states 190 in/lbs with a 1/4 turn. and another one states 270 in/lbs.
Ok I've been working on a 1975 75hp evinrude. One cyl. #3 has shown signes of not running. it's been sitting for sometime. so I started out cleaning carb's, lines, fuel filter and change all three spark plugs. no change. I was using a timing light to check and see if the coil was working and...
I've have shifting issue with this 1989 searay 165 alhpa1 r/mr since I replaced the gimbel bearing and all the bellows except the shift boot. In here I have seen issues with replies that state to adjust the shifter for a mesurement of 6 inches and others that stated allowed movements of like...
working on a 1989 searay with a 165 merc r/mr alpha outdrive to sercive the transom (exhaust, u-joint bellows, and replacing gimbal bearing) My buddy may have pulled on the shift cable at the outdrive, causing the cable to go out of adjustment. I have rev. and neutral but not enough to...
working on a customers force 125hp 1989 , after they had a chance to mess it up. ha ha you got to love it. Anyway when I started looking over the engine I saw that the float level was set to high. when I removed the float bowl I found that : A) the person installed the float upside down. and...
were dealing with a 2000 90hp , 3 cylinder.<br />Carbs were rebuilt checked timing, and adjust it to 2 deg. btdc. Idle was adjusted rpm 900-950 in "N" and in gear droped to 750. The idle mixture was set to 1 1/4 -1 1/2 per. the book. Idle great for hour. with test prop on I ran the rpms up...
I'm building a modified 4 cylindergarden tractor, for pulling a 6500 lbs sled. I want to use a 2 stroke engine, but want to be different from everyone else. The class rules limate the 2 strokes to 1500cc vs. 2300cc for 4 strokes.<br /> The class is loaded with mulity snowmobile engines tied...
