Thanks. Hoping to have scanned today/tomorrow. Last issue showed 3 misfire codes and and 1 EVC code. They were cleared, but ran into alarm/fault issue again last weekend under time running at higher rpm.
Tx
Hi all - was out today and noticed trim gauge was fluctuating between full down and midway while underway doing about 30 knots. Everything seemed fine and wake indicated I was getting good bite. Was planning to have it checked but on way back to marina after about 25 mins engine alarm went off...
Hoping to have engine checked this week to confirm faults and see what's up. Will report back. I thought that if the engine is EVC compatible it can be configured and/or linked into the garmin system which currently allows for chart, sonar, radar, etc. Wouldn't think it would be too...
Update - boat out yesterday and MIL cleared as believe 3 starts since it was triggered, but no warning lights or sounds with the short cruise. However, still rev limited so going to have techs check out.
Nope, I have an MIL only no screen. Its a 2019 bud didn't have the engine data screen option added. Would be worth getting one though! On the list to see if it can added next year. Tx
Thanks. I only have the MIL indicator which shows the yellow engine light or red warning light, its not a panel or screen that can be manipulated. It is to the left of wheel, but no buttons or anything, just visual. If you are familiar with the process to reset let me know. I am going to try...
Thanks so much for this! I have a request in at my marina svs team to have it scanned, but if I get up there in next few days will start up and see how it goes. My tach is not fully accurate either so hard to tell the limit level, but it wasn't able to get up on plane so assume I was being...
Hi all - was out today and got the engine alarm (3 beeps) and yellow warning indicator. I didn't realize I had trimmed up the drive significantly in a rough channel, as such believe it may triggered the alarm. Temp, Pressure, etc all ok. Docked to assess and all looked ok. Upon departing...