Recent content by SHSU

  1. SHSU

    1978 Islander 22 I/O

    I doubled my floor under the pedestals to get the 1.5" thickness. One of the guys on here suggested T bolts when doing the through bolts. Worked out well for me. As for the Grade 8 bolts, you wont be breaking those... lol SHSU
  2. SHSU

    1974 Chieftain 25 "Adventurer" Restoration

    Looks good and like the reuse of the box. Putting any heat shield on the cabinet since it is right over the burners? SHSU
  3. SHSU

    Original 1967 Styrofoam?

    Looks like the original foam I pulled out of my SS16 SHSU
  4. SHSU

    '67 Holiday 18' - Make it Usable

    Looks like the foam I pulled out of my 1986 SS16 SHSU
  5. SHSU

    1974 Chieftain 25 "Adventurer" Restoration

    That is a pretty helm you are putting together. I like the real wood choice. If only I had room for such a large project/boat. SHSU
  6. SHSU

    1978 Islander 22 I/O

    Looks good. I like your choice in vinyl!!! Admiral and I picked the same. SHSU
  7. SHSU

    1978 Islander 22 I/O

    Tractor paint worked well for me too. I used hardener too, but don't know if it was necessary. SHSU
  8. SHSU

    New Journey

    How did you mount the trolling motor on the front? Looks like you used spacers to make it level. SHSU
  9. SHSU

    '67 Holiday 18' - Make it Usable

    There are varying opinions on Salt-Away, I personally haven't tried it so I can't say. That being said, 8 out of 10 trips will be in saltwater for us and I only use water/soap. I would guess that it should be fine, if not primarily used for that and you rinse it off as best you can when you...
  10. SHSU

    '67 Holiday 18' - Make it Usable

    Don't carpet if you are going to use in saltwater. If not, then shouldn't be a problem. SHSU
  11. SHSU

    1997 Mirrocraft 18' aluminum fish n ski

    No idea, but think it should be easy to test. Although doing it with earmuffs might not provide enough water/pressure. SHSU
  12. SHSU

    1997 Mirrocraft 18' aluminum fish n ski

    Can you just have the siren circuit disengaged when the starter is going? Have a simple always closed solenoid that opens when the starer is energized? SHSU
  13. SHSU

    21' 1972 Starcraft Holiday - Splashwell question

    If you splashwell is separating all the time, I would check your transom to make sure it is still good. Something is twisting during use that is causing the stress/separation to occur. SHSU
  14. SHSU

    New Journey

    Man I need that winch system you have. I should have thought of that when I did mine. I used the old engine lift method. SHSU
  15. SHSU

    1976 22' SUS O/B "Hydration Break"

    How is the splashwell holding up when you step on it? I remember when I had the old one it never felt very secure. Might have been just the bad rivets and rotten transom, but seemed to flex a lot under my weight. SHSU
Top