Recent content by singledoubt88

  1. singledoubt88

    Aq125 timing

    I have an aq125b that I am trying to set the timing on. The problem is when I check the current Timing with with my light it reads around what looks like 50* at idle. My manual says it should be around 6. I have an Adjustable gun that allows me to advance and it says I need around 45 * more...
  2. singledoubt88

    78 Johnson 115 stator question

    So I've got a classic case of a JohnRude. When I bought the motor with Evinrude 85 decals on the cowl I assumed that's what I was getting... The plate on the transom bracket has the serial number 85899c. However the plug on the power head reads 115ml78c. The motor has power tilt and trim...
  3. singledoubt88

    Aq125 issues

    So my buddy just bought a 85 bayliner capri with a aq125 and a 270 drive on it, we splashed it for the first time, and noticed a couple problems. I own an outboard I'm just not very versed in I/O's. Any help would be greatly appreciated! The boat idled well on muffs. 1.) when on plane at...
  4. singledoubt88

    78 115 Johnson SS prop?

    What's up fellas, Ok so heres what I'm workin with. I've got a 78 Johnson 115 model 115ml78c. It's a swapped powerhead on a 85 Evinrude with power TNT. The hull is a 1977 starcraft SS 16 footer. I've got the motor mounted on the first hole ( highest point out of the water) without...
  5. singledoubt88

    smart tabs sx on starcraft SS?

    Im looking to buy some smart tabs sx trim tabs and install them on my 16' starcraft SS (1977). Wondering if anyone has installed these with the use of an outboard ladder? Ive got some pretty bad porpoising and planing issues, but i want to make sure i can use a ladder. Thanks fellas
  6. singledoubt88

    OMC pre 95 boat side wiring harness

    Hello, The ground wire in my remote control wiring harness shorted out and melted all the insulation on it and nearby wires destroying most of the harness. My question is that since i am looking to replace it is it possible to use an OMC outboard extension cable like this one...
  7. singledoubt88

    Bent prop question

    Hello, First off I am going to go ahead and apologize as i am a new boater with very little experience, so if i frustrate you guys with my inexperience im sorry. That being said I finally splashed my boat that i have been restoring for the past 6 months. I noticed a couple of problems...
  8. singledoubt88

    78' starcraft ss restoration

    hello everyone, a couple weeks ago i inherited a 78 starcraft SS that belonged to my late grandfather. Having never owned a boat before i had no idea where to start on restoring this thing. thanks to everyone on iboats ive already learned so much about this boat and now have the confidence...
Top