Recent content by Sivart

  1. S

    Need help with a 92 XP200. Dies while underwayUPDATE.

    Well to update on a problem I posted several weeks ago my boat has been in the shop every since then and it turns out (from what the boat shop says)the stator is shorting out the power pack. It looks like I need a powerpack, a stator, and the starter is dragging.<br />I think this bill is going...
  2. S

    Need help with a 92 XP200. Dies while underway..

    I posted a similiar post last year but after the first outing this year the problem has really gotten worse.<br />I can be on the water 2 days of hard boating(stop and go fishing) and never have a problem. Then on the 3rd day I may be hooking it across the lake and the boat will just die (almost...
  3. S

    How to deternine jackplate setback size?

    I have a 92 model Evinrude XP200 on a 91 Astro Quickfire 19FS. The boat measures a little over 20 foot long. I plan on getting a jackplate but I really have no idea on how to pick the right set back size. I see 5,6,8 inch set backs and they go on and on. Can some one steer me in the right...
  4. S

    92' XP 200 pulls right .

    I would like to think everyone for the help and advice with this problem .<br />Dhadley, your advice worked like a charm. The tourque tab mounted on the skeg was the ticket. My boat no longer pulls right at the top end. The ride is much more enjoyable when you dont have to fight the wheel all...
  5. S

    92' XP 200 pulls right .

    My XP 200 is on a 19 foot Astro F/S. At different points in the RPM range this thing pulls to right.<br />I have adjusted the tab on the lower unit as far as it will go and it has helped the problem by 50% but the more I am into the gas the harder it pulls. What is funny about this problem is...
  6. S

    What exactly are the anodes purpose?

    This may be a dumb question, but what purpose do they serve?
  7. S

    92 model XP 200, Occasionally dies during cruise speed.

    Every once in a while my 92 Evinrude XP will just die, almost as if the key was turned off. It has did this 3 times now and I have not got it narrowed down. The first time I messed with the kill switch for a few minutes and then it kicked right off. The second and the third time I did the same...
  8. S

    92 model XP 200, WOT @ 5000 to 5200rpm

    I have a 91 ASTRO 19.5 ft with a 92 XP 200. My max speed is around 55mph at around 5000 to 5200rpm. I can get the rpm's up higher but I do not get any increase in speed. The prop is a <br />14-3/4 x 21 p Viper. When I purchesed the boat I was very concerned with overheating so I dropped the...
  9. S

    92 model XP 200 rpm questions

    I have a question regarding the WOT rpms. I have seen it stressed several times on how important it is to have a set up to get the correct rpm at WOT. My question is what is the proper method to achieve the rpms. My motor hits about 4800 to 5000 rpms without trimming the motor. The more I trim...
  10. S

    Cowling insulation on 92' 200 XP

    My cowling on my 200hp XP, 92 model does not have any insulation in it and as you can guess it is very loud. Can I put insulation in it without causing heat problems with the engine? If I can does anyone have any suggestions on what to use that would be the best to cut down on the noise?
  11. S

    92 XP 200 Evinrude sputtering on take off.

    During take off it seems to load up.About half way through plane it cleans up and runs great to nearly half throttle. At full throttle it seems to "lose" a little torque but when you back off it picks back up. I have installed new spark plugs per everyones advise here a while back. <br />I...
  12. S

    Hot water out of the tell hole.

    How hot should the water be when it comes out of the pee hole on a 92 200 XP. The water coming out of mine is pretty warm. Not near hot enough to burn but it is warm.<br />Another question. When standing at the back of the motor and feeling of the head on the left side of the motor it is not...
  13. S

    Pressure problems, 92' 200 Evinrude

    I installed the new water pump and the water pressure gauge. I hooked up the water line to the adapter just behind my throttle linkage (allen head on the very bottom just above the cowling) I got nothing. I even unhooked the hose and still got nothing out of that port. Maybe a few bubble's but...
  14. S

    92 XP 200, water leak from lower unit seam.

    I plan on replacing the water pump this weekend so I thought I would pick your brains here to see if I needed to look for anything else.<br />At the seam where the lower unit bolts up I have a slight amount of water leaking . After running in the lake I also have oil-gas build up there.Almost...
  15. S

    92 model Evinrude XP 200 question.

    I just bought a 91 Astro Fish N ski with a 92 200XP. THe question I have is the height of the motor on the transom. The top plate above the prop is setting about 3.5 to 4 inches above the bottom of the boat. On the test drive when the motor is trimmed it looks like the water out of the tell hole...
See more
Top