What more needs to be done to clean them properly? I disassembled them and cleaned them with carb/choke cleaner. I can take them apart again, they look pretty clean.
follow up question, when looking at the parts list for these carbs, there is a
MAIN JET #100
3R3032750
and also a
MAIN JET...
I have a 2005 MFS30A. I did not use boat for a long time. This spring it started very hard and ran poorly. I drained and cleaned all fuel lines, took carbs apart and sprayed them out. New fuel.
Checked fuel pump, pumping. Checked compression and it was adequate. New spark plugs.
It starts...
The Throttle shaft is one piece. At this point I am not sure what to do to make this work. I may assemble it without the friction piece, but that would be a real bummer.
I understand the concept of how it is suppose to work. The parts I have are not the same as you posted. I have the diagram posted above to go by, would any of the part numbers have changed or no longer available? This shouldn’t be this hard to get a tiller handle for a 2005 outboard
Hello, Yes that is the part I ordered. I was thinking the friction piece and screw were for a smaller outboard. It seems this model wasn't very popular. It would have been nice to buy the the whole thing as a unit. The service manual is complete garbage as well.
Thanks for your reply. I bought all the parts on this list here to make it a tiller. I am having a heck of time figuring out how parts 16 (friction piece) and 17 are suppose to fit.
https://www.boats.net/catalog/tohatsu/2005/mfs30a-4-stroke-tohatsu/steering-handle-tiller-handle
Hello, I have a 2005 30HP four stroke MFS30A. It is currently hooked up to remote steering and controls. I would like to convert it to a tiller handle. Would it be possible to use the new multi function tiller handle on this outboard?
After getting my 2005 30hp 4 strk back from the dealer for blowing up ignition coils I took it out on the water with a bad outcome. The dealer said there was a wire somewhere that was shorting out and causing it to melt ignition coils and brain boxes. Luckily this was covered under warranty...
I fish in the Southern Yukon Lakes Region of Canada. These Lakes are great for Trophy Pike and Lake Trout. The problem is they do not have lake maps or charts for these large lakes.
Does anyone know of GPS software or Mapping software that would overlay the aerial photo or topo map onto a...
I have a 30hp 2005 4strk Carburated outboard bought new last year. At the end of last season the coil on #1 broke in half and started smoking when I tried to start it. What would cause this. Just a faulty coil or bigger issues? My dealer is a barge ride away so hoping to fix myself or take...
