im going to replace the thermostat on my 1969 55 hp triumph i looked here in the marine store i didnt see a listing for that part for 1969 is there a thermostat that will interchange... thanks for any help
hi i just purchaced a humminbird fishfinder with the speed option paddle wheel also purchased that too, k when i mount this wheel should it be just below the bottom of the transom so it can catch the water flow,im used to the airguide type of speedo,thanks for any info cause it dont say nothin...
ok i have a 55 hp evinrude triumph it has a 13x19 prop im guessing it's a 19 pitch prop, can some one tell me if the 19 pitch is a better top end performer, my question is what pitch is better for top end speed and would a stainless prop help with with speed.thanks for any help
ok to start with this site is the greatest ya'll have already helped me a bunch...thanks, any way heres my next question on my 1969 evinrude 55 hp it has the electric shift ok when i first start the engine (cold start) with nuetral button pushed down it's in forward gear.ok then ill run it...
i just bought a boat with a 1969 55 hp evinrude i dropped the motor in a barrel of water fired it up i didnt see no water pumping out them two little **** holes rite below the cowl isnt that were the water should be coming out of. i took it back to the guy i bought it from local dealer ship he...
k im gonna start my engine it has the hose hook up on the side of the out drive but im gonna drop it in a barrel see if the impellors still good would it be allright to run it with out the prop cause i wanna check the fwd reverse make sure it ingages allright....Thanks
Hi im hoping some one mite beable to help me here,im looking to buy a exhaust elbow for a 1968 OMC I4 153 cu in 120 hp duel carb, engine model number CUE-16C does any body have one of these or know were im can get one...Thanks
Hi i was givin a boat of coarse with no title and i have no idea what kind of boat this is i can say it's 17 foot fiberglass v hull inboard out board, i took some pictures of it but cannot post them here, if some one would post there email i would send some pictures with hopes they might know...
Ok i have a 1964 seaking 45 hp and im looking for a carb rebuild kit.the only problem is this carb is different than any carb ive seen on a seaking,chrysler or force motor this has the square fuel bowl on it,it's a tillitson the only numbers i could get off it were on the base OM20A does any one...
