Why if its dry and good shape no more than I took out of wet probably wouldnt make much difference if it was left out only about a foot square piece was wet there is alot in this boat but I will replace it
As of right now I got the floor out of it to replace it found wet foam right at the back o n the drivers side the rest is dry so Ill probably leave the good dry foam havent got the other side out yet .My motor is probably 2'' high and will that cause it to wash back n forth at low speeds i...
Hi guys I have a 19.5' Sea Nymph SS195 I have an old 1974 Johnson 115 hp on it and sitting on a CMC tilt unit which gives you around a 6'' setback so where should I set the cavitation plate at from the bottom of the boat to be right or close for best performance has a 13.75 x 15 prop on it...
Got an old 74 Johnson 115 it will idle grat when the engine has cooled off but after running down the lake and you shut it off then restart it don't wanna idle keeps dying what could it be motor runs great otherwise just don't wanna idle after being hot
oiK I bought a Sea Nymph SS195 19.5' boat with a seized 88 hp Johnson which had a 13x 19 prop with t x t so Took a motor off my other boat which is a 1974 115 hp and put it on a CMC aftermarket T & T IT HAD A 13.75 X 15 PROP SO SHOULD I RUN THE 13 X 19 AND WITH THE SETBACK[ 5.5''], FROM...
I need to replace the transom in my boat it has a 1'' wood core but I read that everybody puts 1 1/2 '' in should I do this or leave it at 1'' which would be close to 1 1/.2 with the outer & inner skin its on a Seas Sprite tri-hull if I go thicker not sure if the cap will fit the way the...
just bought this thing when running with the ear muffs on water comes out everywhere comes out where lower unit bolts on and a couple little holes on the front and left side whats the problem can anybody help me plz
