Recent content by snakeguy46

Got it, just completed winterizing. Thanks for the book.

Thank you for the info,

Thanks for the info, I thought this may be the case but since the reservoir on the engine had a fill cap it confused me. Would you know it the cap by the pisser is a hose fitting to run the motor out of the water instead of ears?

largereptiles@aol.com, thanks in advance.

This is a very old thread and hope someone can answer my questions. I have the same mortor runs perfect. It is on a 96 Procraft 180 bass boat that looks nearly new. Not sure what the very large 2cy oil reservoir is by the gas tank? Engine has its own reservoir above where the carbs would be...

Switch ID please? Trying to get the aerator to work and not sure if this has something to do with it.

Ok, put new fuel pump on today and new bulb and hose. Pumped up the bulb and go good pressure after four pumps. Engine fired up and idled nice. When given fuel got misfire and stalling. This fuel pump came with a filter so I put it in the line just before fuel goes in the fuel pump and when I...

Good idea,

This is an easy one for you, 6gal fuel tank is new with no build in vent on the cap? Should I leave cap tight or loose for ventilation? I have read through these forums both ways.

Not sure what you meant by fuel pump going hard? I thought about getting a rebuild kit for that. I have done it in the past with other outboards so I feel confident doing it. As for the gap I should be able to check the spark.

Got it, thanks again.

May have to take to a shop for that info, did change water pump in the fall. I just thought if all worked fine in reverse should do the same forward? Thanks for the info.

Hello, first let me say I read many threads here but not sure it helped. We were out in the water last week with fresh gas and oil and we were at 3/4 throttle and all of a sudden the motor gradually slowed down to a bit more then idle speed? We turned around and headed back to the direction of...