Recent content by snicholson

Thanks for the info . I will try it sat. and let you know

I will do that sat. with the coil . I have read 11.8 at the coil and got voltage on the - but did not read the reading . Thanks again

watch them .

they do open and close . I went and bought a starting switch so I could wath them

I also set .019 on points at #1 top dead center . I did make sure I moved the dist. to top point when I set them

Hi Alldodge , I do have amps to coil and to dist. I do not have spark at points . Tried another condensor today and nothing . Any idea's . Thank you Scott

Hi Jerry and friends . Checked the points Jerry , No spark . I put new points in and again nothing . Also had another new condenser and installed . No luck, No spark . Do you think the distributor could be bad and is there any way to check it . Thanks for the knowledge . Scott

I'm on it guys, I will let you know . Thank you Scott

I do have current at the coil . I will try the points monday . Thanks . I will let you know.

I have a 1977 omc i/o ford 230 990230g engine . I have no spark . I have changed out coil , condenser, cap, rotor , plugs and wires nothing . The points look good with little wear . My coil does have good current . I am stuck . Thank you for any input . Scott