Recent content by Snipe

  1. S

    Mildewed Vinyl Upholstery

    What can I use to clean mildew off vinyl? I tried lots of cleaners whithout much success.
  2. S

    For Laddies

    Saw your reply to Andy6374. I just replaced the stator and rect./reg. on a 50 H.P. because of over charging, hanging on a pontoon. This set up is still charging at 16V at full throttle. It will go down some at idle tho. It does not jump right up there, but slowly while we are cruising does go to...
  3. S

    Tachometer Reading High

    Just had the rectifier/regulator replaced on a 3 cyl. 50 hp Mariner 1987. Now the tach reads what appears to be double. Where to look.
  4. S

    Regulator

    Is there a regulator on a '87 3cyl 50Hp ?
  5. S

    Erratic Tach.

    Cruising at low RPMs the tach needle will temporarily jump sharply. Then return to normal. It will do that sporadically. I also notice that my volt meter reads around 16 volts at higher RPMs. It will come down to 14 volts when I turn the running lights on, and stay there at all speeds. Running...
  6. S

    Over Charging?

    On my 50HP Mariner (mounted on a pontoon) the volt meter pegs out at 16 volts at above half throttle. Once it's up there lowering throttle won't drop the reading. If I turn all the running lights on it will drop to just over 14 volts. It doesn't cook the water out of the battery though.<br...
  7. S

    Erratic Tach

    The 50HP Mariner mounted on a pontoon has an erratic reading on the tach. It runs steady and smooth, no miss or carb malfunction, but as we cruise (1800-2000 rpms) every once in a while the needle will jump close to the top. Then it will be alright for a while and jump up again never missing a...
  8. S

    Tilt Assist

    My trim/tilt assist stopped working. Lever moves harder and after taking the nut off, I'm unable to remove the the sleve. Any clues?
See more
Top