On a 1998 115 hp 60* looper what is a general price on all four being rebuilt.
No real problems with them just poor idleing at times-
wanted to keep them in good shape.
I have a 115 hp 98 Johnson 60 LV
It starts almost as soon as I turn the key BUT it runs very rough at idle and low speeds, even after it warmed up.
Once I advance the rpm's it runs smoothly and very well.and smokes seems to stop.
Is there any idle settings on the carbs and can they be adjusted...
On my 1988 Whaler Montauk I have 2 small metal plates one on each side of the hull just under the rub rail. No markings and they appear to be glued to the hull.
Any ideas what they are for ?
I have a 98 Johnson 115 hp-60dg 4 cyl engine and would like to know what happens when your regulator/rectifier goes bad.
What are the indicators that the unit is bad or going bad ?
Does it have any thing to do with the operation of the boats tach and or charging function?
I do not have a volt...
Trying to determine if my voltage-rectifier need to be changed.
My tach reads when off goes about 900 rpm, then when I turn key on to start engine it bottoms out and then goes back to about 900 rpm.
When I give it gas it goes to the bottom of the scale again and stays there until I got back ti...
Replaced the tach cause I thought it was bad on my Whaler 115 OB. The needle stays aroing 900 rpm when off-when starting it goes to 0 them up to about 900 rpm. When I give it some throttle is pegs back down to 0 rpm. Shut key off it goes back to about 900 rpm. What can be causing this.
I have a 1998 115hp Johnson and was wanting in know a simply way to see if the motor is charging the battery.
Where can I hookup a meter to read a charge rate.
My tach is not working but when I turn on the key the tach goes to zero (from its normal 1000 shut off position) like it should. I was told to check my pulse wire to make sure I am getting signal from the engine. I have a 1998 johnson v4- 115 hp and was told that the grey wire on the back of the...
I have a 1998 Johnson- J115 elecm and am trying to find out what the amp output is. Found a lot of spec info but not the amp output. Help needed. Thanks
What is a good liquid cleaner/wax to use on my boat. Just trying to get a little shine back not a years worth of protection from a good paste wax. More concerned with cleaning quality rather than a long term protection.
When replacing the thermostat on my engine ( 98 Johnson 115hp) the thermostat housing uses a internal type ring gasket for sealing the housing to the head. Is it also necessary to us a sealer on the flat metal surfaces that make contact between the housing and the head?
Want to adjust my carbs on a 98 Johnson v4 60dg 115 hp. Locations are hard to get to and I can not see what type of a screw driver head is required. Also is there a adjustment tool made specially for adjusting the carbs due to there locations.
