Just bought the above described motor and need to know how to adjust control arms on the motor. Motor runs but not like it
did when I ran it for about 20 minutes before I bought it. Have ordered a manual for it but want to use it before the manual
arrives. Any photos would help and any...
I have a 1985, 60HP Mariner and a 1990, 60HP Mariner. I have a service manual for the 1985 but not for the 1990 model.
Could someone tell me if there is any major difference in the 2 motors? They appear to be the same. Thanks beforehand
for your help!
I have looked at a Mercury that has 90HP on it and the serial number is OD269003. Can someone
tell me if it is 90HP and what year it is? It is a 3 cylinder gas engine. Thanks for your help!
I have a 1985 60HP, 3 cylinder Mariner. I do have a service manual for it. The motor was used when I
bought it. According to the manual the gray wire from the harness connector is connected to the yellow/
red wire post on the rectifier. But on my motor the gray wire from the harness connector...
Hello Guys: I have the above described motor whose model # is 7060525. I have a question concerning the stator.
This motor was running fine and all at once it quit--glad I had it in the tank instead of on the lake! So I got another
stator, trigger assembly, rectifier, and coil. It cranked...
I have the above outboard with a model #A110868 and S/N #7060525 and I have some questions
concerning parts for the motor. My stator # 398-5704A4 is different from the mercury number which
is 398-5704A7. Which is correct and do I need to buy a new stator? What is the difference in the A7
and...
Hello Guys: I have a 1985 60HP Mariner that I have worked all afternoon
on and haven't got the lower unit to come off the mid section. I do have a
factory service manual and have followed the instructions exactly and have
also drove wood wedges between the 2 sections and all I can get is...
:)Hello Good Neighbors: I am wanting to cover the above aluminum boat and
I want to put 1/16" X 12' sheet aluminum starting at the back and covering 12'
toward the front. I am planning on using white pine 2"x2" for framing post and
2"X4" for framing the roof. All of the post and rafters will...
Hello Guys: On the above mentioned motor, is there a way to replace the impeller without taking
the propeller shaft out of the gear case? I have the 3 bolts out of the gear case to mid section
and am wondering what to do next. Will the top of the splined drive shaft slip out of the power-...
Hello Guys: I have the above motor and man it is trying my patience, which is about 1/32" long.
I have a good spark on both plugs-the spark is real blueish and it will spark 3/4" from the spark
plug port. I tried holding the end of one of the plugs and it gave me a good charge--enough that
I...
