Recent content by speed5

  1. S

    starter question

    is there a way to have the starter push the gear out with out spinning its on a 4.3 V Mercuries with 3 wires to the starter purple red and yellow with a stripe thanks
  2. S

    does anybodt have a 1993 719 cuddy

    i just bought this boat and i think that its missing a the first pad for the back seat any one with photos or help id like to fiqure this one out
  3. S

    green tide

    i was out late last night and saw an amazing sight the jelly fish that glow green when you hit them were everywhere wherer as the wash of the boat was lite green enough to read by has any one ever heard of this it looked like i was flooting on anti freeze
  4. S

    another blown head gasket

    hello i have a 91 v4 115 evenrude outboard with a rebuilt power head after about 100 hours i blew a head gasket wha t causes this problem thank you for your help
  5. S

    hubless prop or not

    hello i have a evenrude 115 v4 motor on a 16 foot larson senza my question is can i put a high performance prop on this motor one without the center tube in the middle or do i have to stick with the original style
  6. S

    please shoot me

    Hello, I have a '91 115 V-4 Evanrude outboard engine.Upon recently replacing the powerhead I tried starting the motor and had no luck kicking it over. Out of curiosity I switched the spark plug wires so plug #1 uses plug #3 wire and # 3 uses # 1's wire and so forth for 2 and 4 also. The motor...
  7. S

    up sizing the carbs

    hello i have a 91 v4 115 evenrude i also have a 140 johnson that does not run can i put the 140s carbs on a 115 and is there any hp changes or is it a waste of time
  8. S

    is wires right or did i have to many

    hello i just put a new powerpack or my 91 115 v4 evenrude and had a backfire problem i put wires in right order and double checked them time and time again still a problem but after switching them where 1 and 3 wires are switched and so on for 2 and 4 it ran fine is this ok or is something...
  9. S

    cannot remove motor

    i have a 115 v4 evanrude motor that im replacing with a rebuilt unit im having trouble removing the power head with all the bolts and nuts removed i still cannot lift the motor off. the problem is that the 2 threaded rods behind the exaust cover seam to be frozen in place i tried wd40 for a...
  10. S

    water pressure

    hello is there any way to put a pressure guage on a 1990 115 v4 evenrude had a bit of a problem with a garbage bag and dont want it to happen again
  11. S

    tirm is backwards

    hello i just installed a new trim sending unit on my evenrude 115 1990 motor it works but it says up instead of down and visa versa. i wired it the same way as the old one and even switch the wires with no luck evend switched wires around on guage to please help thank you
  12. S

    will it fit

    hello i was just looking to repower my 90 115 hp evenrude due to a slight problem with a garbage bag my question is when i look up for a replacement power head it comes up from 110 to 140 hp will a 140 hp block fit on a 115 frame or mount in is same place if going to spend money why not...
  13. S

    more power

    I have a 115 hp is there any performance tricks to make this a faster running motor
  14. S

    more power

    I have a 115 hp is there any performance tricks to make this a faster running motor
See more
Top