Well I am fairly new to boating and this is my first post to this forum. The last time I took my boat out I went to a new launch. It was about 7:00am when I put the boat in the water. My brother in law was holding the boat when I tried to pull the trailer out. As I pressed on the accelerator my...
I noticed the other day that I have a broken wire on my 76 85HP Evinrude. Things seem to be running okay but I was just wondering what it could be. It is the black wire that connects to the main terminal strip on top of the motor. It appears to be coming up from behind the round thing in the...
I have a 1976 85HP Evinrude that has recently been rebuilt. Currently it has about 10 hours on it. This past weekend I noticed for the first time that around 2500 RPMs it begins to shake and chatter, almost like it isn't in gear. I can run it fine at a lower RPM or any higher than about 3000...
I have lost the detent lever spring on my carb. Click on the link below for a picture. It is a late 70's 140HP Evinrude. Any idea where I can find one? Any help would be appreciated. Thanks. Also, how do you add a picture directly to a post?<br /><br /> http://www.outboarddealer.com/carb.htm
My Evinrude shifts into gear fine, forward or reverse, when I apply a good bit of force to the control. When I just ease it forward to creep along it sometimes sounds like a car trying to go into gear without pressing in the clutch. Is this normal or should I make some adjustments? It does go...
I have a 1976 85HP Evinrude that has just been completely rebuilt. I have followed the break in procedure listed in the manual, one hour at 3000 RPMs and second hour at 4000 RPMs after that run normal except for WOT or high RPMs for the next eight hours. Does this seem appropriate or should I do...
I have a 1976 85 Evinrude that I often run with 6 gallon portable tanks. Often I don't pay attention until the motor dies when the tank is empty before I switch over to another one. Can this cause any major damage to the motor?
I have a 1976 85 Evinrude that I often run with 6 gallon portable tanks. Often I don't pay attention until the motor dies when the tank is empty before I switch over to another one. Can this cause any major damage to the motor?
I have a US Marine control box and for some reason when I am in neutral the engine will not idle and to go into forward or reverse I have to really push fast on the throttle to get it moving or else the motor dies. If I really jam it down had it runs fine. Any ideas? I just can't bring it close...
Good evening all! I have just recently purchased an old fishing boat with a Force Outboard and have been trying to do some routine maintenance. I found that the heat sensor was in rough shape so I purchased a new one. The sensor has one purple wire and one brown wire coming from it and under the...
