FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
So I'm back again and this time I took my carberator apart and found a little rubber piece that searspartsdirect called an element. This piece on my crab was ripped on the sides. Coinsicidently my engine is flooding and running at maybe 1/4 throttle while I have it at wot. Do you think this...
I have a 7.5 gamefisher and Im replacing the impeller but noticed there is a notch in the shaft that a key would normally fit in. But there wasn't one. My buddy ordered a impeller pin which is a short straight pin which would usually go through the shaft but there is no hole in shaft for pin to...
I have a 15 ft fiberglass tri hull and it has a few nics and dings in it. It has some flex seal that i put on myself and some yellow lookin stuff that was used by previous owner. Any ideas on how to fix my hull? Just to add in i have pressure treated plywood floor with carpet so i can't see the...
I have a tri hull that has a rough looking bottom. I think some areas need redone. I also tried to use the flex seal stuff you see on tv. So do i have to sand it until i get to the hull or what?
So i have an 89 sears gamefisher 7.5hp and it cranks on first pull and runs like a sewing machine but the first time out it was kinda hesitant and a little skippy. After about 5 mins of use it shut off and smoked. The man i bought it from said he was told that there really wasn't supposed to be...
So i have a 15 ft fiberglass trihull and a 1984 dt3.5 suzuki on it. Haven't brought it to the water yet and wanted to know if it would be enough to get me where i needed to go. Speed is not a issue. Just getting from point a to point b and then back to a. the rivers here arent that fast moving...
So I've got the lower unit loose and i see two pieces of broken plastic. One on top of a plate and another below it. What are these? How do i take the lower unit all the way off? Its still attached to the rod going up to the motor. and behind the prop there's a pinion gear that looks like its...
