My 1980 70 hp evinrude runs fine until I get to around 4,000 rpm. after that it sounds real loud like a gear is slipping and wont go until I slow it down again. any ideas what the problem is?
also i have a starting issue. when I turned the key to start nothing at all happens. I took the cover...
I have a 1992 195 Bayliner with an I/O 3.0 liter engine with out a trolling/kicker for back up emergency/trolling.
I wanted to know if I mount my 9.5 short shaft evenrude as a trolling/kicker on it. I've only seen long shafts mentioned it my forum searches. I have no experience with using this...
I have a 1993 bayliner bowrider with the left side windshield broken out. I got all the pieces out but not sure how to get a new piece in as the frame is rivoted.
its a flat piece of glass and was hopeing to replace just the glass with out replaceing the whole windshield if possible.
It...
i posted this in the repair section by mistake ill try again here
I have an 1969 9.5 short shaft Evenrude in storage. it ran before it was winterized before storing. its spent its whole life indoors when not in use been in storage for since around 1996 when i upgade boats. it has low hours and...
I have an 1969 Evenrude in storgae. it ran before it was winterized before storing. its spent its whole life indoors when not in use been in storage for since around 1996 when i upgade boats. it has low hours and used in pa fresh water no more than an average of 10 trips per year.
I was wonder...
