FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
I have 71 Evinrude 3 cyl 60 hp., it has only two mounting bolts. The plate just above prop is 1" below bottom of 15' v-bottom Fiberform surfrider. Am getting lots of spray towards corners of transom, some coming into motor well. Bolts are now about 2.5" from top of transom, any suggestions on...
My 1971 60 hp runs good, however, when I adjust idle on #1 carb there is no difference in rpm no matter where I turn screw. I put carb kits on all 3 carbs, runs great at speed. Any suggestions?
I have 71 Evinrude 60hp with cdi 113-7123. What (if any) tach will work with this setup. I have an old Airguide with two wires, yellow and black but don't think this will work since motor has conversion box. Thanx
