i have an 89 force 125. i had power to the engine and i found out that my starter and solenoid are bad, so i replaced them and now when i turn the key to on and push in the key the choke engages but if i leave the key on for more than 10 or 15 seconds my negative wire connected to the battery...
when i try to start my engine my starter shoots up fast and then cant turn the wheel. so it took jumper cables from my car battery (with it still on) and connected it to the starter thinking that i might have a bad starter.but still it would shoot up and then barely turn the fly wheel. so i...
i just recently bought an 88 force 125hp and i have the power cable hooked up to the motor and to the ignition switch, but i cant seem to figure out how to get power to the switch from my fuse box. is there a wiring diagram that i get that would show me how to wire it to the fuse box?
i have a force 125hp motor and i would like to repaint the motor because it is looking a little sad on the paint. where can i get decals for the motor cowl because i plan on sanding the entire motor down and then repaint it.
i just bought a 1988 force 125 with power tilt and trim. my boat has ever had power tilt and trim before and all that came for wires on the tilt motor was 2 wires about 12" long. how do i hook them up to the throttle controls or do i have to buy a seperate control for it, also how do i hook it...
i have a 1990 90hp mercury outboard that i was able to tilt it down but now it wont tilt back up to take to a repair shop to look at and i dont know how to manually tilt it back up. what do i do? i can hear the motor while going down but no noise at all when i try to tilt it back up.
