Recent content by stresspoint

  1. stresspoint

    Could I use isolator to charge AGM battery

    defiantly not if it were me , as posted AGM requires regulated charging. although it will keep the AGM charged , the life of the battery will be shortened and the charging system on the motor may get damaged ??. AGM battery's are basically the same as wet cell but are a little more fieky how...
  2. stresspoint

    Yamaha lower unit stuck

    are all the bolts out ?
  3. stresspoint

    One last try

    give a couple of days riding a knee board , i hadn't skied for 25 years and had a shot , needles to say i had no hope , a couple of days on a knee board and i was skiing in a strait line , ha ha tried cutting but fell every time , no arm strength . i have a training bar that i could have used...
  4. stresspoint

    salt water in single cylinder

    yea mate , busy being single ! OP , test the block and head for a crack , , test the exhaust and inlet port on that cylinder , they have a tendency to rot around the stem area .
  5. stresspoint

    salt water in single cylinder

    start looking for a split in the engine block. hey there Lou .... :)
  6. stresspoint

    Have spark and fuel, can't get the rebuilt engine to start

    your timing is off by 180 , take the rocker cover off the #1 cylinder side ( most forward cyl is #1 BTW). set the valves so the springs a full expanded on both valves , this is now compression stroke ! . remove the dizzy completely from the motor , put a paint mark where #1 lead is on the dizzy...
  7. stresspoint

    2008 F250 4 stroke. low compression / bad am phaser?

    that lll do it ! easy fix ,
  8. stresspoint

    2008 F250 4 stroke. low compression / bad am phaser?

    to answer the question ' yes' if the "phaser " was to get stuck for some unknown reason then yes it would play havoc with compression on one bank. that being said , you would also have limp mode or a no start situation, if on a vehicle the dash would look like a x mas tree. when was the last...
  9. stresspoint

    Can I Tell if Water is Getting into the U-Joint Bellows?

    it appears to be squashing the rubber on the bellows a little much for my liking , in an area like that it is critical to have thick rubber making contact with the metal surfaces , a squashed surface reduces the thickness of the rubber .this can also make the clamp act as a knife as the bellow...
  10. stresspoint

    Can I Tell if Water is Getting into the U-Joint Bellows?

    ""You suggest checking for a leak after tightening the hose clamp onto the shield (If that is what it is called) How can you check for a leak except by removing the OD ??""" my comment was in general on the tightening ( yes i know you cant see in there ) , as posted " it was probably not what...
  11. stresspoint

    Mercruiser 4.3L won't start

    +1 have the battery checked oe swap it out for a known full power one , these motors take a a lot of cca to fire them up . on that note the starter could have an internal short causing slow crank and taking power from the ignition.
  12. stresspoint

    Car Hood Boats

    kids today will never understand the challenge of not being killed by their best mates . we once used a Holden EH bonnet tied behind a YZ 465 Yamaha full speed through/ across a wheat field. no one killed that day "" surprisingly "
  13. stresspoint

    Old motors DEMAND to be retired when they are 65 years old..

    2001 + stuff ,cars boats , motors whatever , its usually the electronics or wiring is what sends them to scrap piles to come back as kias or these days teaslers!.
  14. stresspoint

    Car Hood Boats

    ahhhh the memory's of using car bonnets for stuff other than closing engine compartment's , dirt roads and paddock bombs brings back memory's of some scuffed elbows and shoulders. OP sorry for off track , the boat bonnet seems like it would kick on now days whack a big assed motor on and go ...
  15. stresspoint

    Mercruiser 4.3L won't start

    is the lanyard key in place , is the shift in neutral " sometimes you have to click them about a bit if the boat has sat "". start off going over the simple stuff first before swapping stuff out . you say "" i bought this boat "" ? had it ran in your possession before this no start occurred
See more
Top