Hello all,
Need some suggestions on a aeration/wash down pump. I currently have a ?Tsunami T800 Aerator? using it for live well and wash down. I really don?t have much pressure coming out of the end and would like to upgrade it to a high capacity pump. I?ve seen the ?Rule 405STC? which puts...
Shout out to all you lower unit tech heads.
I've got a 2002 Suzuki 4-stroke DF140 25" extra long shaft and was looking for a lower unit for it. What are my options on replacing this? I'd like to keep the same gear ratio and all that. Is there a year range of Suzuki lower units I can use? Can...
Hello all,
Looking for any help I can get. Wondering if anyone has any connections or ideas on where to find a used or re-manufactured lower unit I need. I'm trying to find a lower unit for a 2002 Suzuki 4-stroke DF140 with a 25" extra long shaft. Don't know if the short 20" shaft would work...
Switched out my OEM spark plugs with Autolites.....I'm assuming a spark is a spark is a spark. Gaped them according to manual, so far no problems, started right up.
No problem or big mistake?
Thanks in advance.
Hello all,
Long story short.......motor been sitting for a few weeks with no activity, had regular unleaded fuel in it. When to the lake and started it up, sounded rough at idle. Got it out on the water and gave it some gas...sputtered for a while and then stalled. Had a little bit of a hard...
Hello all,
Okay lately I've been doing a lot of night fishing on large to medium sized lakes or out on the inner-costal waters down in Texas. When I'm boating around at top speed I usually navigate using my "one billion, trillion candle power spot light" to see where I'm going (as not to run...
Hello all,
I'm looking for some parts to my 2002 Travis edition Fish Master bay boat.
1st I'd like to get some suggestions on where I can buy some cargo door replacement latches (see pic). They measure 3 inches square?
2nd I'm also looking for some bulb housing replacement for my green/red...
Hello all,
I've been getting my boat ready for saltwater fishing here down at the Texas coast. I looking to buy and install a cavitation plate for the shallows. Looking for some advice on which brand and type to get. I've got a 2002 22' Travis Fish Master bay boat with a 2003 Suzuki 140 on...
Hello all,
I know that its kinda normal for outboard to have somewhat of a gear grind when putting into (forward/reverse) gear. There was a time when my gear shifting was smooth as butter but now has a "clank & grind" when shifting back and forth. What can I do or check so I can reduce this...
Hello all,
I?m putting my Suzuki df140 lower unit back together. I asked the boat shop guy to order me some Anti-Seize Lubricant so that my screws will not corrode or rust in the future (salt water boat). The Shop guy said ?Oh you mean dielectric grease?sure.? He stated it was the same thing...
My boat currently has the E-T-A brand thermal breakers on it and I've changed my pumps out and they require a diffrent amp breaker. The ETA band only make 5 amps and up, "needed" a 3 amp breaker but guess my question is.....which brand breakers are the most popular and easy to find in most amp...
I've got a 2002 Suzuki DF-140 and trying to pull the prop shaft housing out. The manual calls for a slide hammer to do that but I don't have one. I've improvised and am using a puller instead. Please look at the pic attached and tell me if it is okay to do it this way......before I start...
Hope this is the right spot for this question.
I've got a CMC Jackplate and I'm thinking my actuaror has gone bad. Is there a way of testing it to determin if its burned out or bad?
If broken or burned out, can it be repaired?
Thanks.
