Recent content by surfcaster52

  1. S

    150 hp water pressure gauge

    Where can i get a water pressure reading from 150 v6 1996...and what do i run to the gauge thanks glenn cape cod
  2. S

    150 HP V6 TEMPERTURE GAUGE

    IS THERE A WAY TO INSTALL A SENDING UNIT TO GIVE AN ACCURATE TEMP READING OF MY 1996 150 CARB. OUTBOARD.......I HAVE A TEMP GAUGE INSTALLED ON THE BOAT THAT READS 100 TO 240 DEGREES FROM MY MERCRUSIER I/O TO OUTBOARD CONVERSION AND WOULD LIKE TO MAKE IT WORK.......... THANKS....... GLENN
  3. S

    1996 mercury 150.....gismo

    I have a puffing sound coming from my motor.......it is coming from what looks like a drain fitting located on the bottom starboard side right underneath of the starter. It seems to be spitting out air and some water. there is nothing attached to this but it looks like there should be a hose or...
  4. S

    1996 mercury 150 water pump problems

    would any one know what merc part # 85822A10 does (connector assembly)......looks like some kind of return tube in the lower unit..........i just replaced my water pump assembly and it will not pump water and looking at a schematic of the lower unit my motor has nothing where this connector is...
  5. S

    150 merc 1996 trim and tilt stuck

    help........ I just replaced my lower unit after doing a water pump replacement and trimmed the motor all the way up and now it will not move down......... any help would be greatly appreciated:.....:/
See more
Top