thanks. so you just filed the ferrule off and clamped new hose to the original end fittings? that would work for me. good to know there is no unusual pressure to worry about.
hi folks. does anyone know any cheap options for replacing the internal fuel lines on a merc 65 3 cylinder? maybe the source / specs for the ferrule and end fittings so i can make my own?
i have acquired a neglected 1974 merc 650. i got it running on muffs and every single fuel line inside...
i have an old but solid and functional morse command 200 rack steering system for a 14' boat. anyone know if i can use the teleflex 10 degree wedge tilt kit fir their rack system with the morse to shift the angle of the wheel? looking at photos on the internet the morse system looks awfully...
hi, this is a new to me 1974 50 horse evinrude lark with manual trim. looking for advice on whether the anemic prop bite in reverse is normal or i need to adjust something or replace the prop?
i do not have much experience with pre-1980 outboards but i've run lots of other circa 50 horse...
hey folks, i have a parts anomaly question where i think the sierra info on this site may be wrong.
i have a 1984 long leg 3 cylinder 70hp johnson.
brp/evinrude lists the water pump kit for this as p/n 438602 for this motor
brp/evinrude lists a different kit, 432955 for 1986+ years
here's...
i have a 1985 v4 looper and i am looking to update the cowl cosmetically. i am considering buying a clean looking replacement cowl from a 1993 that would require a drive to check out. the seller does not have the lower cowl parts. do i need the lower cowl parts as well or will the 85 lower...
model is 200 txerk
i am rebuilding the carbs and noticed there is a large open hole in the bottom of the silencer backing plate below carb #5. it is visible in bottom right corner of this photo.
my parts manual says there is a "grommet, hose" p/n 329518 that goes here (diagram is for 1994...
i am hoping this is unrelated to my power issues in the other thread.
what is the best way to flush sand out of the cooling passages of a 1994 evinrude 200?
i bought boat/motor long distance. it arrived with the cowl pee hole blocked with sand and about two inches of sand behind that. i...
looking for where to go next. i think i have a carb problem and need to rebuild starting with #5.
last november i bought a boat long distance from a guy who never took it over 4000 rpm. it was winterized and fuel was stabilized in november but it has sat since then due to life getting in the...
how much work would this take and what parts would i need to replace while i am in there? i am fairly handy with a full set of normal tools but have never tried messing with a lower unit.
long story short, i have a 1985 johnson 120 with a v6 long leg on one boat that is unpowered, and a chance...
can someone summarize the history pros/cons of the early v6 looper models? i have figured out the xp is a crossflow, and that after about 1992 the looper v6 changes into the intruder/first strike model with a different cowl. but what about the 86-90 looper v6s? they seem to sell at a...
need help picking where to jump next.
I have purchased a new boat and I seem to be underpropped and I'm looking for some suggestions as to where to go as it is looking like I'll have to make a leap of faith as I can't find a dealer nearby with a prop I can demo. I am going aluminum to s/s, and...
