Can anyone give me a straight forward way of adjusting multiple carb. setups. Most of the manuals I've refered to don't go into any detail on this. I'm afraid using the "ear" method is not what the factory had in mind. I'm afraid this leaves too much room for error. Also, can anyone give me...
I'm rebuilding a '92 60 Hp evinrude for a friend. He burn a piston out so I had that cylinder bored .020 over. All of the rings and bearings were replaced . The compression checks as follows #1(new piston)120, #2 110, and #3 110. Is this acceptable? The other two cylinders were honed and as...
A friend has a 2000 40 Hp 4 Stroke he would like to put electric start on. My question is two part. 1: Does anyone know where I might be able to get used parts(flywheel, starter, etc.) 2: Is the timing pulley and the flywheel one piece?<br />I have taken a quick look and it appears that...
I know this is a pretty common problem on any brand of outboard. I have gotten such great responses on this forum, I figured this was the place to start. Does anyone have any secrets or tricks for getting stuck flywheels off? I think I have tried them all. Biggest question I have is what do...
I have a 1995 C75. Several years ago I was at a repair shop and an old mechanic told me that Yamaha actually offered kits to upgrade motors and increase Hp. He also said this would not void any type of warranty since their tolerances are so tight. I know that this is probably possible to do even...
O.K. You Merc. guys, I need some real help! This motor is on a boat my son bought the first of the summer. I pulled the carbs. and installed kits after cleaning. I have checked sync,timing,compression, firing etc. Motor cranks and runs fine at idle. As the throttle is advanced the motor...
I have listed various questions for this motor and have had little response. I decided to tell the whole story and maybe someone can help. Thsi is a 1992 115Hp V4. It lost compression on one cylinder and was sent out for a rebuild. When it was recieved back from rebuild it was reinstalled...
Can anyone give me a source for the seat in the carb. This one is pressed in and as far as I can tell the dealer says you have to buy the whole carb. The mod.# is NS25B.
Recently I read a post that had a method for checking WOT timing without running the engine. J.Reeves method sounds like the ticket for checking this but he informed me the motor I have('92 115Hp) has a "Quick Start" function which would not allow me to use this method. My question is two fold...
Any ideas on best place to order OEM manuals. I was given the name of a company,Ken Cook for the older manuals('95 and earlier). The last one I checked on was for '96 225Hp and it was around $80. Anyone know of a cheaper place? I guess you still have to get the newer ones from the dealer???
Is there any rcommendations as far as service manuals go? I know the general consensus is probably theres nothing like the OEM manual but if you had to use an aftermarket manual which one would it be? The Clymer Manuals assume too much information is already known so they skip steps and lack...
I noticed a post earlier that told of a way to set WOT timing. My question is will this work on any OMC(specifically a '92 115Hp) and do all of the wires have to be connected to a spark tester or just the #1 wire?
This boat has an OMC Systems Control gauge on it. The problem is the no oil light will come on, the buzzer will sound for ten seconds and then stop but the light stays on. The VRO is still pumping oil as indicated by the exhaust & the level in the reservoir. I have been told it could be the...
