Hello, I have a mercruiser 3.0 (2007) Do I need to have the motor running when I torque the six bolts when connecting the lower unit to the upper housing???
Hello, I have a 2007 Mariah with a merc. 3.0 over the weekend I replaced the impeller, and now the engine overheats on the muffs. What could I have done wrong????
I have a 2006 mercruiser 3.0 alpha 1 gen.11 I noticed the bell housing gasket on the sterndrive is split, will this let water into my sterdrive and is this a hard repair to fix. Also what gasket sealant do I need????
Hello, I have a 2007 Mariah 18FS - I have installed four round led lights, the problem is how do I connect them to my acc. switch. My acc. switch has power to it now and has three terminals on the back please help
Hello, Could somebody help with these concerns, I have a 2006 mercruiser 3.0
1. Do I check the oil once the engine is hot and running??
2. I use Gear Lube plus rom mercury - where is this oil used??
3. What oil do I use for my trim/tilt
4. I have a oil resevoir mount on the side of my engine...
Hello, I have a mercruiser 3.0 ( 2006 year) with the alpha one drive, I am getting close to my 100 hour service to be completed on my engine . What all should I be asking the service shop to do. Should I ask for anything extra to be done???????????
Heres what I would like to do
I have installed LED lights in my boat I would like ti use only one switch to control all four lights. What I would like to do is turn the forward two light on or the aft two light and then all four light at the same time. What kind of switch can do what I need...
]Hello, I would like to install a total of four LED lights in my boat (exterior lights ) two of the light will be placed towards the bow and the other two lights will be placed aft midship.
1. How do I connect all four lights together
2. Is their a way to turn the front and rear lights on...
Hello, I have a Mariah FS18 with a mercruiser 3.0 I would like to install a thru hull transducer in my boat (the one that you have to drill a hole) The spec on my boat states the dearise is 18 degrees.
1. Is the entire hull 18 degrees or portions of the hull ???
2. How and where do I measure...
Hello, I have a 2007 Mariah FS18 with the mercruiser 3.0 I would like to change the fuel pump filter, but how in the world can you get to it and when you do how is it replaced?????????
Hello, I have a Mariah 18FS with the mercruiser 3.0 with a TKS carb on it (2006) I do I replace the carb filter. It looks like were the filter goes is a solid piece and does not look like it would unscrew. any ideas????????
Hello, I have a 2007 Mariah ES18 and would liketo mount a thru hull transducer. Do these transducers get drilled thru the botton of the hull or the transom????
Hello, I would like to give my Mariah FS18 with the mercruiser 3.0 a good tune-up with the following items. Please advise if anything else is needed
1. Cap and Rotor
2. Plugs and plug wires ( what is best?? )
3. Carb filter
4. Fuel filter
Do I need anything else????????
Hello, I have a Mariah 2007 FS18 with the mercruiser 3.0 in it. If I hold the steering wheel at 12 o clock I can move it to the 11 and 1 o clock positions before I have any movement in the steering is this normal and if not how can I fix this issue????
