I need fuel tank cap for a Johnson 2003 3.5 hp J3RSTF P/N 114800, but this part is N.L.A. from BRP acording to my local dealer, and seems have not aftermarket equivalent .
Do you think a fuel cap from Tohatsu's build Mercury is the same ?
Or another alternative ??
Thank you
Suzuki 90 hp four strokes 2001 run 2000 rpm in idle
Code 3-2 (Map sensor) and 2-2 ( CTP switch)
Checked the CTP and have no continuity when giving throttle, seem to be normal
Checked and clean the IAC, engine stull when disconect
Is there a way to check MAP sensor ? Engine drop to at...
There no fuses and no relays on this particular manual start motor.
Acording to wiring diagram, the ECM direcly apply power or ground to the fuel pump.
Mercury 4 strokes 25 EFI 2006 S/N 0R146130 manual start
Costumer install New Quantum hi pressure fuel pump not working
Receive 12-15 volts DC from de ECM (pump disconect ) when pull start, but 0 when pump is conected. If i plug the fuel pump on a battery the motor run good.
Is the ECM...
Finaly after changed the uper crankshaft seal and the idle was about 75 % better
Also changed the top ignition coil after found a cracked magnet and the holeshot is now good and the idle too
Happy customer !
Thanks for your help !
Just removed the exhaust covers : Sleeves are ok ( not rotated) , pistons rings and pistons skirts are like new .Ordered news gaskets and whil try whit the new upper crakshaft seal ............
Yes for sure the motor is not use until i find the trouble, but i dont think is the carburetor because that make no difference ( in idle when i change the top and bottom
i haved order a new one and try next week because when i removed the flywheel for check the seal, i't just maybe a little bit oil around it , but i'm not sure it will make a lot of difference like that a hi RPM but the new is ordered anyways .
Mercury mid '90 75 hp 3 cylinders S/N 0G039179
When run idle , remove the top spark-plug cap (cyl no 1) and make no difference at all.
No power on the water, bad holeshot.
-Compression is 125 PSI on all the 3
- Ignition is very strong on all 3
- Clean all carburetors , drain all fuel and try...
