Recent content by Tafflad

  1. Tafflad

    VP drive failed again ... 3rd replacement

    Just as a minor correction. I said in OP boat had only done 100Hrs ..... I was wrong-checked today - its only 72Hrs
  2. Tafflad

    Notification not working

    Anything I can do or anyone to contact ?
  3. Tafflad

    VP drive failed again ... 3rd replacement

    I have asked VP last year and they did not recommend any sprays. They have been very good at providing new drives …so don’t want to compromise any warranty position. it does seem logical to use something.
  4. Tafflad

    Notification not working

    I have preferences set to give me notifications on comments on posts I created or posted in. I get no notification emails ….When I do login, at top right there will be notification of alerts on the ‘bell’ icon. just nothing coming to email
  5. Tafflad

    VP drive failed again ... 3rd replacement

    Not aware of Boeshield, looked on line it says it leaves a wax like finish, you advising this as a one off job, or before each use ? Maybe similar to ‘Corrosion Block’. (Marine ver of ACF50) https://www.acf-50.eu/marine I have that, I could use.
  6. Tafflad

    VP drive failed again ... 3rd replacement

    On both times it failed it started on the sharp corner where the bearing carrier is (as in picture) My question was if the large amount of stainless in the DP set up caused excess electrolytic issue. There was focus on the bonding, but all proved correct. I think the sharp corners had thin paint...
  7. Tafflad

    VP drive failed again ... 3rd replacement

    This is what drive went like after about 15 Hrs use ... in salt water, flushed with Fresh water until up to temp, then Salt Away, then washed & rinsed. VP advised use to send of season , then they would resolve. The inspection report said: The corrosion we are seeing on your drive is happening...
  8. Tafflad

    VP drive failed again ... 3rd replacement

    I posted previoulsy about corossion issues requiring replacement of VP drive. https://forums.iboats.com/threads/280-c-n-corrosion.763231/#post-5831700 I have a VP 280 C-N engine with DPS drive, posted here of serious corrosion on the drive with is on a non-moored boat. VP replaced it under...
  9. Tafflad

    Skeg Q

    Thnx
  10. Tafflad

    Skeg Q

    Do you have a link for this product, not familiar with it.
  11. Tafflad

    Skeg Q

    I'll certainly be painting. Probably just file the notch smooth.
  12. Tafflad

    Skeg Q

    This is not engine specific, so seems correct sub-forum. Noticed on checking over drive that the very ‘point of the rear of the Skeg has snapped off / chipped off. Only talking about 5mm triangle. I could just file it smooth, and paint. or is there a filler …. Plastic metal, etc. I could...
  13. Tafflad

    Paint ok our code ?

    Is this used on all 'silver' Volvo outdrives ? Also is there a specific primer - I'd buy at same time
  14. Tafflad

    Paint ok our code ?

    Have 2023 Volvo Penta DuoProp silent shift drive (on a 280-c-n ) Does anyone know correct paint code for this ? or where I can find it.
  15. Tafflad

    280 C-N. Corrosion

    The dealer came to my house.. and found the cables not adjusted properly.
See more
Top