Ok thinking buying a bigger boat but I drive a 2010 Mazda tribute AWD 2.5 4cyl max towing weight is 1500 lbs. Now this might be a silly question but I know you add the weight of the boat and motor together but do you also add the weight of the trailer
My mariner has a really low idel even when warm it will cut out when ideled down anyone have a diagram as to where the idel screw is and how many turns out it should be set at and idle RPM Thanks
Hello i just picked up a fisher bass boat with a 100 hp 2x2 mariner runs great at low speed but when you open it up has some issue's . I pulled the plugs top 2 look fine bottom 2 black but the plugs in it don't have the nipple;s what plugs would be considered the best for this type of motor Thanks
I have looked at the charts in the fourm but can't seem to find the age of this 1 100 hp Mariner 4 cyc its either DA758743 OR OA758743 Thanks for any help you can give
Ok i'll start with boat 1991 16ft foxcraft weight 940 pounds tack don't work need to figure out how to fix this boat had a 1991 75hp merc and did 42mph i picked this johnson up cheap from a used boat dealer who stands behind his work so no isues there. There is a stainless steel 21p prop on it...
ok this is a small bass boat i just had a new T/T motor put on it but it still will not plain right im thinking maybe it was either put back on too high or low with the bolts right now its set in the 3rd hole from the top any suggestions if i should drop it down more
16ft foxcraft with 75hp motor good compression and just had T/T motor replaced but it still will not plain any suggestions on if i should lift or lower the the motor at the bracket right now its in the 3rd hole and as 2 holes above and 2 below or anything else i should try Thanks
Ok where to start motor runs great and up untill lately had lots power twice in the last week it has started great and run good just a lack of power no speed i have checked the filters in the gas tank and on the side of the motor tried new plugs. Is there something else i could check before...
after reading alot of posts about problems with these i have a 1990 75hp and decided i'm just going to undo the wires and premix the oil and gas Is it as easy as just takeing the wire's off Second we have no Merc dealers near by will auto carb cleaner work the stuff that mix's in the gas...
ok my tilt&trim motor has stopped working in the down position how whats the easiest way to get at the motor as it's behind the plate. Look's like if i take out the bottom bolt for the rams or what ever there called i should be able to lift the motor manualy. Or does the motor have to come off...
i bought a boat and moter last fall was told 1991 model since the boat and trailer were both 1991 i took the guys word the motor was aswell but just had to have the starter rebuilt and was informed the starter has 1989 on it would they have used an older starter and where can i look up my...
Ok where do i start. I bought a small bass boat last fall with a 75hp 3cyl Mec so far the starter won't even try engageing and the trim only works in the down position. I'm starting with the inline fuse's 3 of them were wrapped in foil and 1 was in peice's now i know there is 1 20amp? right...
Question i bought this last fall late was told the trim needed a bushing in it it worked going down but will not go up another suggested it was the silonoid for the tilt and trim i see that 1 of the connecters have no wires going to it anyone have any ideas or some diagram i could use that...
