Here’s what I have done thus far.... cleaned a plastic fuel tank made sure the vent is proper. New fuel lines including inside the engine cowl. New primer bulb.New fuel pump diaphragm. Rebuild carburetor. Installed new points and gapped them at 30k.runs fine at high idle or starting position and...
I have a 1965 mercury 110 9.8 hp that has these two hoses installed on the fuel pump. Both are old, cracked and leaking. Where can I find the exact replacement of these hoses? Or what are some other options? Thanks
I have a1965 mercury110. 9.8 hp. The only water I see coming out of the engine is at the upper exhaust. I cannot find a pee hole. I was wondering if it even has one and where would it be
I have a 1965 mercury 110 9.8 hp that I am restoring. Looking at the drive shaft, should there be an O ring at the bottom of the spline on the drive shaft?
I am changing the impeller on a 1965 mercury 110 9.8 hp. I did not pay attention to the water inlet tube that connects to the impeller housing cap. the cap or top of the impeller housing can go either way, but what side should the water intake hose be on. etc prop side ? or front side?
