I have a 91 WellCraft with a 5.7L volvo penta 501 with a 290 outdrive. The tilt will not tilt up. The tilt down and trim down works but not the tilt up.
I am rebuilding a '91 WellCraft with a Volvo Penta 5.7L 290 AQ125 outdrive. I am trying to assemble the indicator wheel at the steering helmet but am not sure how it all works together. Does anyone know of an illustration pertaining to this problem???
I have a 1991 Wellcraft with a volvo penta 290 outdrive. The steering helmet broke off and I am replacing it. The problem I have is removing the old stem. I removed the retainer bolt and have gone as far as drilling a 1/2" hole and inserting a 2.5 pund dent puller but I cannot seem to get it to...
I am removing the lower gear unit and there are 2 bolts of the 7 that are just being quite stubborn. I have used a penetrating spray and have gone through 3 sets of allan wrenches. Are there any suggestions to free up my stand still??
How much will I be looking at to fix the outdrive. The only thing I see damaged is the steering fork kit and hook up fork. So, with labor and parts am I looking at selling my first born?
I need to remove the outdrive on my 91 wellcraft. This has a volvo penta 501 V8. The steering fork kit and hook up fork are broken and need to be replaced. It seems that the only thing holding up the outdrive is the drive shaft and boot. How do I remove these?
....two parts that hold the outdrive to the rear assembly. It looks like the two swivel pieces that mounts the outdrive are seperate pieces. But I am an amateur and do not know what to ask for when I shop. Anyone know of an illustration of an outdrive that breaks down the parts???
I live in St. Augustine, Florida and am looking for someone that would have a starter that will fit a volvo penta 501. Are there any parts locations near St. Augustine or Jacksonville or maybe Daytona???
Is there a post that illustrates the wiring for the instrument panel of a 91 wellcraft. There are terminals that are diconnected and I need to know where they go
The boat had been sitting for about a year. I was able to turn by hand the entire motor about 1/2" before it would not budge. There is a clicking sound at the relay but nothing at the starter. What should I do next? Do I try to remove the starter and test it off the motor??? Please advise.<br...
