Recent content by THOMASTHETANKENGINEBOB

  1. T

    force 90hp seizing

    Hi can anybody tell me when my engine was trying to seize, number 2 was the worst, but number 1 was not scored at all
  2. T

    Force 90hp L drive piston part number?

    Hi can anybody help with telling me which are the correct Pistons I need? I purchased new Pistons from wiseco part number 3164p3 when I tried to fit them I discovered that the wrist pin is too big as it measures 0.770 inches and my original wrist pin measures 0.658 inches, contacted the person I...
  3. T

    Timing

    Can anyone help with the timing on a mercruiser 4.3 do I just point and adjust or is there a special sequence my engine number is ok003191 and it is a thunderbolt ignition thanks
  4. T

    starter motor 4.3 swap

    Hi all my mercruiser 4.3 has a 4 pin starter motor which one of the pins has a purple wire to fuel pump this starter motor is broken I have a spare with 3 pins can I connect the purple wire somewhere else
  5. T

    have i damaged my volvo sx

    hi i have a Volvo pent 4.3 gl with sx leg i was running engine in tub of water and i let water get hot noticed leg was making more noise than normal so stop engine took dipstick out oil seemed bit bubbly and little bit of air came out was it making more noise because of being hot will it be ok...
  6. T

    4.3 timing

    can someone tell me the timing on a 1995 4.3 gl volvo someone has painted white line at 6 btdc is this correct
  7. T

    holly 2bbL mixture settings

    hi can somebody tell me the factory mixture settings for a holly 2bbL 500 cfm on a volvo penta 4.3 v6 all books tell me different settings
  8. T

    help with valves

    hi i am having a problem with valves on a Volvo pent 4.3 V 1995 i adjust the valve lash like it says in manual then give it a full turn to seat them then after ten minutes they are all lose again the only way i can get them too adjust correct is too tighten nut all the way down so it wont turn...
See more
Top