I removed the bolt to latch in order to remove stat cover but bolt is too long so I can't get the latch and bolt out of the way. So I am asking for suggestions. I replaced water impeller with kit and decided to flush upper by hooking hose to copper intake. A little dribble out of pee hole . So I...
I removed bolt to latch but it is too long to come out and get out of the way of stat cover so should I remove power head to access water intake to see if grommet is smashed. If so what gasket/ kits do I need to put her back. I installed impeller kit then hooked up hose to copper intake to flush...
Hi < I replaced water pump etc. and hooked hose to copper intake water comes out hole on r. side of motor underneath( tube feeds it from a small block.) no real water comes out pee hole. Is this a concern prior to reassembly? After reinstalling lower unit and testing does water come out of pee...
I don't have key for the control unit so I can't engage starter motor to test 82 johnson 35hp. can you get key or by pass simply to try to start and test motor? The 9.9 is set up to start electric also. It has seperate control (standard f and reverse once in gear you can accelerate . I don't...
I tested 9.9 86 no water pee, pushed weed wire up no change . The 35hp has more modern controls with key hole . I don't have key and want to test motor. Any suggestions as to how to engage starter motor for test??? Thanks
I am fortunate to receive boat with 2 motors .I ask of your assistance for ID help for correct year to order parts. 35 Johnson model number J35ECND; serial no. E5652999 and a 9.9 h.p. model no. j10ECDB; serial no. E6164085. They are in great condition but have been sitting for 20 years. So...
Today I received great instructions here on how to examine clutch dog. Is there a way to adjust shift rod or check to see if that is problem? Do i take off lower unit to do so? I replaced impeller not long ago and wonder if I messed it up. It was a gift so I don' know the history. Thanks again
does anyone know if someone has one of these gems that could help ? No body seems to be old enough. The only old outboard mechanic I knew had a stroke. Thanks
I drained lower drive unit by removing lone phillips screw at bottom starboard side. does that screw secure the shift rod as well? If so do I have to disassemble the gearcase to properly realign the components to reinstall the screw. Also does anybody have picture of motor with shift cable...
Is there a thread on procedure for reinstalling new cables. Questions come to mind about greese, Moving parts? Also correct assembly so I don't have kink like previous set up. Set screw at control box then reassemble then set screws at motor?Gear and throttle controls in neutreul position? My...
How do I identify which cable to order for johnson controls (Shipmaster) I suspect they are original for 59 glasspar with 35 hp johnson. The shift cable appears to have a bit of twist when you connect to gear shift and creeps back out of gear. I followed instructions for put in neutreul then...
I was curious if folks disconnect fuel line and gear linkage at motor when travelling. I ask because of the stress on cables when motor is up and tilted seems a bit more than if motor is down.
Pressure plate no scores . Is that plate all that seperates the oil from bottom?1 of the ports or the two had more resistance but I could blow through easily. I have fished out lines housing looks perfect. Any ideas. I am going to take it apart again tomorrow morning and compress air throughout...
