Recent content by tnash542

  1. T

    warning buzzer

    just bought a 1994 23ft bayline with a 3.0 mercruiser with 383 hrs on it. i was looking at the wiring yesterday and noticed that there was a wire off in the front of the motor. i put it back on where it looks like it came off and the motore started to buzz . i called to boat store and they...
  2. T

    trailer brakes

    hey guys i just bought a 23ft deck boat with trailer, the only thing wrong with the deal was he told me that the trailer brakes didnt work. its got the kind that the tongue pushin in to apply the brakes. my question is what is the most common thing that goes wrong so i can try that first.
  3. T

    water temp gauge

    Hey guys i have a 1994 3.0 mercruiser .My question is ,is there a way that i can put a second temp gauge in my boat for a backup just in case the primary doesnt work right. If so where on the motor would do this. and do i have to use the sending unit type. just looking to protect my...
  4. T

    mercriuser 3.0 frozen ?

    I have a 95 motor the starter went bad , engine been sitting a while is there a way to turn the engine over ? there is no way that i can see since the motor doesnt have anything to to put a socket on and the motor backet is in the way. dont want to buy start if motor is froze. thanks todd
  5. T

    removing fuel from tank

    I was wondering the best best way to remove fuel from my tank in the floor of the boat, my boat is a 96 bowrider . i was told there was a valve in the tank that will stop me from getting it out,
  6. T

    old gas

    how do you get gas out of a boat if the tank is in the floor. gas has been in the boat for about 1 year sitting and im sure it had to go bad . didnt want to start boat with old gas .
  7. T

    low oil presure

    I just started my 1996 3.0 mercruiser up after sitting about 2 months. i was puzzled that the oil pressure was really low from last time i started it. this time is barely moves. only when i increase the rpms, it move a little. is this a problem or is this normal for sitting a while.
  8. T

    wire problem

    hey guys i got a older 35 evinrude electric start motor. someone took off the soleniod and key switch, i got a manual but i still cant figure it out,, i need to know what wires have to be hooked up to make it run, i bought a new key switch and soleniod. thanks
  9. T

    90hp inline 6 idle problems merc.

    hey guys i got a inline 6 that will only start a full throttle. it runs great,but when i back off the throttle it shuts off . carbs clean. new gas . when im backing off the throttle about amost at idle, it starts poppin and breakin up , but when i put it back to higher rpms it runs great...
See more
Top