A small leak on the top nut of my hydraulic line on my trim tilt. Pain in the ass to get lose and find one it's a 94 115hp yamaha. Any suggestions at all. Can I change to a flexible hose mine are stainless now. ? Anyone know??
Yea I believe your right I'm going to go through the whole system this up coming weekend. I'll let you all know what I find to possibly help out someone else with the same problem. Thank you all for your help and direction to go
Ok great I will go through my water system this weekend and change things out . It's about time anyway. I usually do it winter time. But can't go out with it like this so might as well go through it. Thank you so much for your help. How would I check the coil packs to know what one is bad?
No it only does it while on the water. In the driveway at idle runs great. Only does it after open throttle for like 2-3 minutes. Not hard to start. And has not stalled out because of it
No it only does it while on the water. In the driveway at idle runs great. Only does it after open throttle for like 2-3 minutes. Not hard to start. And has not stalled out because of it
I have a 94 yamaha outboard 115hp 2 stroke. It will run for about 2-3 minutes great. Then goes into almost limp mode sputtering.. have checked fuel filter, ran it until it sputtered then tried pumping ball it was hard couldn't pump. Not sure if it could be a fuel pump or something different...
