Hi guys
I have just bought a 1998 Sea Ray 280 sunsport with twin 350MAGs in from a place in spain, the boat is spotless inside and out and has had very little use unfortunatly I dont think is has been as well maintained as it looks, this isnt really an issue as I can do this stuff my self...
Hi guys
I have a 1998 mercrusier 350mag mpi I have a very slight crack on my inlet manifold probably caused my frost at some point although its not causing any issues I would like to change it to stop issues in the future
Where is the best place to source one also are there any performance...
Hi guys
I am probably wanting the impossible I am looking at getting a new sports boat/cuddy
I ideally want twin engine somthing like 350Mags
25-29 foot long
Weighing no more than 7000lbs
1998-2006
The nearest thing I can find is a chaparral 285ssi but is just too heavy to tow here in the...
Hi i wonder if you guys can help i was unsure weather to put this in here on in the trailer section but here goes
I have a Bayliner 2352 capri cuddy 1999 with a 350 mag mpi with bravo 1 stern drive
i have had the boat for just over a year and tow it on a trailer but it tows horible and i think...
hi i have a 1999 bayliner 2352 cuddy it has a 1998 spec mercruiser 350 mag mpi with a bravo 1 drive
now i have a craving for some more power and happened to find a procharger kit on the net not 100% sure it was for my engine or the later ones but anyway just after some info on it if anyone has...
i have a 350 mag mpi 1998 modle with bravo 1 leg
it starts and idles fine and if you rev it nice and slowly its fine but if you bang the throttle down in netral or in gear it just bogs down and cuts out then to start it you have to hold the throttle at WOTand it turns over for a few seconds...
hi i have a 1998 350 magnum with bravo 1 out drive it is raw water cooled
should the engine get up to temp at idle or say driving at 6 knots?
i have only just got the boat and i have always had out boards which have never got up to temp unless flat out
as the 350 has a thermostat i expected...
do any of you use the K&N marine flame arrestors?
i have a 1999 mercruiser 350MAG EFI and am thinking on getting one it prob wont make any difference but looks as though it will filter the are as well as doing the normal job the standard thing looks pathetic lol
any way on the K&N website the...