im in need of some help, my prop has seen better days and am wondering what new prop would work best for me. i only use the boat for fishing and use electric mostly,but what prop would be best for all around torqe and speed when motoring from across the lake. pitch? 4 blade? at a reasonable...
i have a 1988 21' crest pontoon with a 75 horse mercury longshaft motor, the prop i was told by the previous owner was for pontoons. the pitch or numbers on prop are 2832-13 and at wot i am at 4100rpm and begin to cavitate. mercury said i should be at 5000 to 5500 rpm with said motor. the motor...
I bought a used aluminum fabricated products 18 gallon tank. I put a new sending unit in it and
cleaned all the fittings for the gas line hookup and new teflon tape. Now to the question the tank has
a breather tube about 3/4", should i block that tube off so i get pressure built up in the...
a friend and i gutted and rebuilt this aluminum boat from the hull up. new floor, seats, electrical and so on, the only thing we did not put back in the boat is the livewell. after a year we are very happy with the way it turned out but, it is leaning to the side the livewell was on while on the...
i have a 21' crest pontoon with a 1986 75 hp. mercury motor,the cavitation plate rides about a inch below the water when boat is not moving just
sitting in the water. i have a 3 blade prop with 2832-13 stamped on it. at wot the boat is going along at 4100 rpm and then it revs and the boat...
i have a 21' crest pontoon with a 1986 75 hp. mercury motor,the cavitation plate rides about a inch below the water when boat is not moving just
sitting in the water. i have a 3 blade prop with 2832-13 stamped on it. at wot the boat is going along at 4100 rpm and then it revs and the boat...
i have a crest pontoon 21' with a 1986 mercury 75 hp. long shaft motor, the numbers on the prop are 2832 13 im thinking that is the size and pitch. anyway at wot the boat revs and slows down,i back off the throttle and it stops until i wot again. wierd thing is it does it most of the time but...
i have a crest 21' pontoon with a 1986 75hp outboard mercury on it. the boat holeshots
great but at wot it revs. adjusting trim is out of the question motor has to be all the
way down. i read on this forum the rubber behind the prop goes bad and could cause
this,marked it with nailpolish...
